Jenn-Air Parts

Checked and found the evaporator frozen causing the fan to stop working. Took the interior panels off and applied a blow dryer to the ice, once the ice melted I cut the tabs on the grommet holding the fan since everything is thin plastic and replaced the grommet and fan. Placed everything back and found no further issues. Tools I used were a small flat head screwdriver to pry the panels off and a 1/4 socket to remove the center drawer (4), water filter cover (2), and the ice maker (2). Not too... Read more

I watched the video at your website. I unplugged the electric first. When I opened up the machine up, It was loaded with lint.I found the source was a hole in the vent tube outside the machine. I fixed that first . The lint had been sucked back into the machine. The first half hour was spent vacuuming out all the lint and then I could proceeded with the motor change. I followed the video exactly. I removed the screws at the two front corners, after lifting the top and controls and tying it... Read more

Replaced the motor with a direct replacement part. The wiring was not the same because the switch on the motor was different. The instructions that came with the motor were enough for me to figure out what to do. Read more

Replaced the motor and fan blades exelente fitting work great Read more

The evaporator fan had stopped working and caused the entire area around it to ice up. No air flow was getting from the freezer to the fridge. I replaced the damper control (it was rusted, not sure if it was workign or not) and the evaporator fan. It was a very quick repair once I diagnosed the problem. The most time consuming part was taking all the compartments apart to get to the affected area. Read more

Added a new shaft as the old shaft had worn down...........works perfect now. Thank you Easy fix ....no more than 10 mins. Read more

Replaced evaporator fan in back wall of freezer. Read more

I replaced the cooling fans (the upper one was totally burned out). Oven (13 years old) works like new now. Read more

• Noisy
• Freezer section too warm
• Fridge too warm

Removed back panel in freezer compartment. Held on by four hex head screws. Disconnected wire assembly from panel and then replaced evaporator fan motor on kitchen table. Evaporator fan motor is attached to back side of freezer panel by four hex head screws. Easy repair to do.It took me about 30 minutes to do the repair. Read more

Removed bottom cover plate and unscrewed motor housing Read more

I replaced the downdraft fan and fan motor of my 25 year old JennAire C301 cooktop. The issue was getting the fan/motor assembly out in such a tight place. I had to first remove the fan cover, cut the wires, then the assembly came out. Putting back wasn't as tough although getting the cover back on (over the motor) was a bit of a strain. Wired it back, turned it on, and was thrilled. Now I'll replace the knobs and burners and we're back in business. Read more