Kenmore / Sears Bracket & Flange

Rear mounting bracket that secures the evaporator fan motor in place. Replace if bracket is bent, cracked, broken, or missing hardware attachment points.

Mounting stirrup bracket for refrigerators. Secures internal components in place. Replace if broken, bent, cracked, or missing to restore proper support.

Replace the right-hand mounting gusset bracket in your top-mount refrigerator. Needed when the original bracket is cracked, broken, or missing.

This timer mounting bracket secures the appliance timer assembly to the cabinet so the timer stays aligned and stable during operation. Replaces a worn or broken bracket to restore proper timer support and reduce vibration. What it does:

• Holds the timer/timer motor firmly in place on the control panel or chassis
• Prevents the timer from shifting or rattling during cycles
• Helps maintain proper gear alignment for accurate cycle timing
• Commonly replaced when bracket is bent, cracked, or missing mounting studs

• One timer mounting bracket

• Basic hand tools required; disconnect power before beginning repair
• Inspect related fasteners and the timer housing for additional damage
• Handle the timer assembly carefully to avoid damaging wiring or connectors

Right hand

This console support bracket secures the range or oven control panel, keeping the console aligned and stable for reliable button and knob operation. It restores proper panel fit and reduces movement or rattling during use. What it does:

• Provides structural support for the appliance control console or control panel
• Keeps the console aligned so switches, buttons, and knobs operate smoothly
• Helps stop console sagging, looseness, vibration, or rattling during operation
• Prevents stress on wiring and switches by holding the panel in place

• Disconnect power to the appliance before beginning any repairs; for gas ranges, shut off the gas supply.
• Support the console or control panel while removing fasteners to avoid dropping the panel.
• Use the original mounting screws and fasteners; align the bracket before tightening.

Dryer burner mounting bracket secures the gas burner assembly in place. Replace if cracked, broken, or missing to properly support burner components.

Mounting bracket for laundry center units. Secures components in place. Replace if bent, cracked, or broken to restore proper structural support.

This mounting bracket secures internal components in place to keep appliance parts aligned and stable during normal use. Replacing a damaged bracket restores proper fit and support for affected assemblies. What it does:

• Provides structural support for internal panels or assemblies to prevent shifting and noise
• Helps maintain proper alignment of moving parts to reduce wear
• Stops rattling or vibration caused by a broken or bent bracket
• Keeps connected components securely attached after repair or reassembly

• One mounting bracket

• Disconnect power and water before starting any repair
• Inspect surrounding fasteners and hardware; replace any stripped screws for a secure fit
• Use proper-size tools to avoid damage to mounting holes or nearby components

Mounting bracket for dryer assembly. Secures internal components in proper position. Replace if bent, cracked, or broken to restore structural support.