Need Help?
Call or text
Mounting bracket that secures the water valve in your refrigerator. Replace if the original bracket is cracked, broken, or missing to properly support the valve.
Supports and stabilizes your refrigerator door for proper alignment. Replace if bracket is cracked, broken, or causing door misalignment issues.
Replaced part. Read more
Usually ships within 4 - 14 days
Wall-mounted safety bracket that prevents range tip-over. Includes bracket, screws, and instructions. Replace missing or broken brackets required by code.
The installation was simple. I pulled the range away from the wall, took a measurement and screwed the bracket to the wall. Then slid the range back into place making sure the foot of the range went under the bracket. Read more
This front-and-rear mounting bracket secures the appliance's front and rear assemblies to the cabinet, restoring proper alignment and support. Replacing a worn or damaged bracket helps reduce panel movement, rattling and improper fit. What it does:
Secures and supports internal compactor components to keep panels and assemblies aligned. Replaces worn, damaged, or missing brackets for firm installation.
The compactor failed with the ram down, so the drawer wouldn't open which in turn made the mounting brackets inaccessible. This necessitated sliding a thin oscillating saw blade between the cabinet face frame and the counter top to cut through the brackets. It was then possible to roll the unit out and place it on its side. I removed the five screws holding the bottom pan in place, dropped the pan exposing the gear/chain train. The large gear was cracked from shaft out to the edge. One of... Read more
Metal mounting bracket that secures internal dryer components to the frame. Replace if cracked, bent, or broken to restore proper alignment and stability.
Replacement mounting bracket for ice makers. Secures interior panels and trim for proper alignment. Needed when brackets are broken, cracked, or missing.
Stacking kit bracket module that secures your dryer on top of a washer. Replaces cracked, broken, or missing brackets to restore safe stacking.
Just installed the kit with clear instructions. Read more
Secures the top or front panel to your laundry center frame. Replace if bracket is cracked, broken, or missing to restore proper panel alignment.
My washer and dryer was stacked and I needed the right parts to put the tops and "feet" back on them. Read more
Secures the evaporator cover inside your refrigerator's freezer compartment. Replace this metal bracket if bent, broken, or missing to restore alignment.
Mounting bracket that secures the thermostat assembly in your dishwasher. Replace this bracket if it's cracked, broken, or missing to restore stability.
Lower hinge bracket that mounts at the bottom of your refrigerator door. Replace if cracked, bent, or broken to restore proper door alignment and support.
Replacement mounting bracket for your washer. Secures internal components in place. Order a new bracket if yours is cracked, bent, or missing hardware.