Kenmore / Sears Bumper, Bushing, Grommet Parts

Rubber grommet that cushions and seals the door switch assembly. Replace if cracked, worn, or missing to restore proper door switch mounting and function.

Step spacer for refrigerators. Installs between components to maintain proper alignment and spacing. Replace if cracked, broken, or missing.

Small mounting clip that secures panels and trim inside your refrigerator. Replace when broken, cracked, or missing to restore proper fit and stability.

Door bushing for refrigerators. Installs in door hinge assembly to cushion door movement. Replace if worn, cracked, or missing to restore smooth operation.

Replace your worn or missing refrigerator door bumper. This small plastic part cushions the door and prevents damage to the cabinet interior.

This snap bushing is a push-in grommet that secures and protects wiring where it passes through sheet metal openings, helping prevent wire chafing and wear. It's a simple replacement that restores proper wire routing and protection. What it does:

• Holds wiring or harnesses in place at panel openings to prevent rubbing and abrasion
• Cushions wires against sharp edges to reduce the risk of wire damage and shorts
• Maintains correct wire routing to prevent pinching when panels are reassembled
• Common symptom: visible chafed insulation or loose wiring at an opening

• One snap bushing (quantity: 1)

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Access the panel or opening where the wiring passes through; remove any retaining screws or clips as needed
• Press the bushing into the hole until it snaps fully into place, then route the wire through the center
• Inspect surrounding wire insulation and replace or repair any damaged wiring before reassembly

This is a retainer clip used to secure internal components in place within a freezer. It holds parts firmly in position to prevent shifting or rattling during normal operation. Replace this retainer if the original is cracked, broken, or missing, which can cause loose or misaligned components inside the unit.

Rubber bushing that cushions and supports the washer tub assembly. Replace if worn, cracked, or causing excessive vibration during the spin cycle.

This small hinge spacer positions and supports the refrigerator door hinge assembly to ensure proper door alignment and smooth opening. It helps restore correct door spacing and prevents rubbing or uneven sealing when the hinge is worn or misaligned. What it does:

• Provides precise spacing between hinge components so the door sits and closes correctly
• Stabilizes the hinge wing to reduce door wobble and uneven movement
• Helps correct minor misalignment that can cause door binding or uneven gaps
• Works with the hinge assembly hardware to maintain consistent door sealing

• One hinge wing spacer as shown

• Intended for use with the door hinge assembly; verify hinge location before ordering
• Basic hand tools typically required; refer to your model's service manual for disassembly steps
• Disconnect power and empty the door as needed to avoid injury during service
• If hinge damage or heavy wear is present, replace the entire hinge assembly rather than only the spacer

Metal shim that installs under the bottom refrigerator hinge to level and align the door. Replace when worn, bent, or missing to restore proper door fit.