Kenmore / Sears Clip Or Clamp

Secures electrical contacts to your refrigerator compressor. Replace if loose, damaged, or causing electrical connection issues. Verify fit with your model.

A small spring-style hose clamp that secures appliance hoses and tubing to fittings to help prevent leaks and hose separation. Simple, durable clamp replacement for worn or damaged hose connections. What it does

• Holds rubber or plastic hoses firmly on barbed fittings to maintain a sealed connection.
• Helps stop water or air leaks caused by loose or deteriorated hose attachments.
• Reduces movement and rattling at hose connection points during operation.
• Commonly replaced when clamps are corroded, stretched, or no longer spring-tight.

• Disconnect power and water supply before servicing the appliance.
• Use pliers to open the spring clamp, slide into position, then release so it seats evenly around the hose.
• Inspect the hose and fitting for damage; replace hose if cracked or brittle.
• Wear eye protection and gloves; ensure clamp sits behind the hose barb for a secure seal.

This clip is a small mounting retainer used to secure panels, trim, or wiring inside the refrigerator. It restores proper fit and reduces rattling or loose parts for a quieter, safer appliance. What it does

• Holds panels, trim pieces, or wiring harnesses in place to prevent sagging or separation
• Stops vibrations and rattling caused by loose components
• Prevents wiring from rubbing or catching on moving parts
• Helps maintain correct alignment of removable trim and access panels

• Inspect the mating surfaces for damage; replace any broken mating tabs before installing the clip
• Push the clip into the mounting hole until it snaps securely; verify the retained part is firmly seated
• Disconnect power to the appliance before working near electrical components
• Use hand tools only and avoid force that could break adjacent plastic parts

This cable tie secures wiring and small hoses inside the appliance to prevent rubbing, snagging, and vibration-related movement. It's a simple replacement part for restoring proper wire routing and keeping components tidy and safe. What it does:

• Holds wiring harnesses and loose cables in place to reduce wear and chafing
• Helps prevent wiring from contacting hot or moving parts
• Reduces noise caused by loose wires or hoses
• Keeps connectors and lines routed for reliable operation

• Disconnect power to the appliance before servicing
• Route wiring as shown in the appliance wiring diagram or photos, then cinch the tie snugly—do not overtighten
• Trim excess tail and ensure the tie does not stress the wire insulation
• Replace any damaged wiring or insulation discovered during installation