Kenmore / Sears Clip Or Clamp

Secures range wiring to the cabinet to prevent loose or pinched wires. Replace if clips are broken or wires hang loose. Verify fit by model number.

This clip is a small mounting retainer used to secure panels, trim, or wiring inside the refrigerator. It restores proper fit and reduces rattling or loose parts for a quieter, safer appliance. What it does

• Holds panels, trim pieces, or wiring harnesses in place to prevent sagging or separation
• Stops vibrations and rattling caused by loose components
• Prevents wiring from rubbing or catching on moving parts
• Helps maintain correct alignment of removable trim and access panels

• Inspect the mating surfaces for damage; replace any broken mating tabs before installing the clip
• Push the clip into the mounting hole until it snaps securely; verify the retained part is firmly seated
• Disconnect power to the appliance before working near electrical components
• Use hand tools only and avoid force that could break adjacent plastic parts

This cable tie secures wiring and small hoses inside the appliance to prevent rubbing, snagging, and vibration-related movement. It's a simple replacement part for restoring proper wire routing and keeping components tidy and safe. What it does:

• Holds wiring harnesses and loose cables in place to reduce wear and chafing
• Helps prevent wiring from contacting hot or moving parts
• Reduces noise caused by loose wires or hoses
• Keeps connectors and lines routed for reliable operation

• Disconnect power to the appliance before servicing
• Route wiring as shown in the appliance wiring diagram or photos, then cinch the tie snugly—do not overtighten
• Trim excess tail and ensure the tie does not stress the wire insulation
• Replace any damaged wiring or insulation discovered during installation