Kenmore / Sears Dispenser Parts

Black grille that sits at the base of your refrigerator's ice/water dispenser to catch drips. Replace when cracked, stained, loose, or missing.

Channels ice from maker to dispenser opening. Replace if cracked, broken, or missing to prevent ice scatter and jams. Installs in freezer door dispenser.

White plastic grille that sits beneath the ice and water dispenser to catch drips and spills. Replace if cracked, stained, or missing for a clean look.

Fix detergent leaks or dispenser jams with this washer detergent housing assembly. Routes detergent properly and replaces cracked or warped housings.

White overflow grille for refrigerator water/ice dispenser. Replaces cracked, pitted, discolored, or missing grilles. Snaps into place below dispenser.

Detergent or softener not dispensing properly? This dispenser drawer assembly deposits detergent at the right time. Straightforward replacement.

This ice door motor drives the dispenser flap that opens for ice dispensing and closes to seal the chute. Replacing a weak or failed motor restores smooth door movement and helps prevent warm air and moisture from entering the freezer. What it does:

• Actuates the ice chute door during dispensing and returns it closed for a proper seal
• Helps reduce frost, condensation, and ice clumping around the dispenser
• Can address ice not dispensing due to the door not opening/closing
• May resolve clicking or grinding noises from the dispenser area

• Unplug the refrigerator before servicing; wear cut-resistant gloves
• Remove dispenser trim/control panel to access the ice door assembly; handle wiring carefully
• Note linkage and wire orientation before removal to ensure proper reassembly
• After installation, test the dispenser to verify the door opens/closes and seals the chute

Protective cover that sits over your dishwasher's pump inlet to screen debris. Replace if cracked, broken, or missing to protect internal components.

For single drain outlet models only. For dual outlet port models you must order the complete pump and motor WD26X10013.

Detergent not dispensing during wash cycle? This actuator arm with spring releases the detergent cup at the right time. Moderate DIY repair.

Detergent cup not opening during wash cycle? This actuator lever connects the timer to the dispenser lid. Moderate DIY repair, about 35 minutes.

Replacement outer door panel cover for dishwashers. Restores exterior appearance and shields internal components. Needed when original is cracked or damaged.

Drip tray collects defrost and condensation water beneath your refrigerator. Replaces cracked, broken, or missing trays to prevent leaks and floor damage.

Dispenser facade cracked or discolored? This trim assembly restores your refrigerator's dispenser appearance and proper fit. Straightforward install.

Replace a cracked, broken, or missing dishwasher cover. This protective cap installs on your dishwasher to cover internal components and fittings.

Fix a dishwasher that won't release detergent or leaves soap residue with a new detergent dispenser. Moderately easy install in the door panel.