Kenmore / Sears Dispenser Parts

Dispenser facade cracked or discolored? This trim assembly restores your refrigerator's dispenser appearance and proper fit. Straightforward install.

Replace a cracked, broken, or missing dishwasher cover. This protective cap installs on your dishwasher to cover internal components and fittings.

Replacement dishwasher housing assembly that encloses internal components and aligns panels. Use to replace cracked, warped, or damaged housings.

Covers the electrical junction box where the power cord enters your dishwasher. Replace if cracked, broken, or missing to protect wiring connections.

Fix exposed fasteners or openings on your washer dispenser with this protective cover cap. Keeps dirt and moisture out while restoring a clean finish.

This wet agent dispenser replaces the washer's liquid fabric softener dispenser to restore proper dispensing during the rinse cycle. It helps keep softener contained until the machine is ready to release it, improving rinse-time performance. What it does:

• Holds and releases liquid fabric softener (wet agent) into the rinse cycle
• Ensures softener is delivered at the correct time for even distribution
• Stops leaking or premature release when the dispenser housing is intact
• Commonly replaced when the dispenser cracks, clogs, or fails to dispense

• Disconnect power to the appliance before starting any repairs
• Access method varies by model; remove dispenser drawer or top panel per your model's service instructions
• Inspect surrounding seals and clips; replace if damaged to prevent leaks

Fix rinse aid leaking from your dishwasher dispenser with this wet agent dispenser assembly. Moderate DIY repair requires inner door panel removal.

Fix a broken soap dispenser with this dishwasher dispenser door housing. Restores proper detergent dispensing when the housing is cracked or damaged.

This water tank assembly holds and delivers chilled water to the dispenser and ice system, restoring proper water flow and preventing dispenser dry-running. Direct-fit replacement designed to match the original reservoir's form and function. What it does

• Stores and supplies water for the refrigerator dispenser and ice-making components.
• Replaces cracked or damaged reservoirs that cause leaks or loss of water supply.
• Helps resolve intermittent or no-water dispense when the tank is compromised.
• Works with the refrigerator's fill and drain pathways to maintain correct water levels.

• One water tank assembly

• Disconnect power and shut off the water supply before servicing.
• Drain remaining water from the lines and tank to avoid spills during removal.
• Handle the tank carefully to avoid damaging fittings or mounting tabs.
• After installation, restore water and power, then check connections and test for leaks and proper dispense/ice fill.

Fix detergent not dispensing or drawer stuck issues with this washer dispenser. Simple DIY fix for soap buildup and dispensing problems.

Fix detergent not dispensing or dispenser door not opening with this dishwasher dispenser shaft kit. Repairs broken or worn dispenser mechanisms.

Detergent or softener not dispensing properly? This dispenser drawer assembly deposits detergent at the right time. Straightforward replacement.

Dispenser funnel guide ice door for side-by-side refrigerators. Guides ice from door dispenser into your glass. Replace if cracked, broken, or damaged.

Collects defrost and condensation water under the freezer drain area. Replace if cracked, warped, or leaking to prevent puddles and water damage.

This is the replacement body frame that secures and finishes the appliance front, restoring proper alignment and appearance. It provides a rigid mounting surface for the front panel and helps keep internal components protected from dust and debris. What it does

• Replaces a cracked, warped, or damaged front frame that causes gaps or poor fit
• Restores correct alignment of the front panel and door openings
• Covers and protects cabinet edges and mounting points from wear
• Helps prevent rattles and vibration by providing a stable mounting surface

• Frame/body replacement part

• Disconnect power (unplug or shut off breaker) before starting any repair
• Remove the front panel or door assembly per the service manual to access mounting screws
• Handle edges carefully; use proper tools and keep fasteners organized for reassembly