Kenmore / Sears Gasket & Seal

The gasket is fairly straightforward: it's just a press-fit right in to the channel. What you need to know is that you need to stretch the gasket material lengthwise prior to installation; if you don't it will be too short. The problem is that the bottom seal is not included with this gasket kit. The bottom seal begins to loosen at the corners and then begins to allow water past the door. The only way the bottom seal is sold is as part of the inner door assembly, which is costly. I removed... Read more

Replaced it with new gasket, took two minutes to replace it.No tools required Read more

Found dryer portion I let plastic had failed to keep seal. Ordered new blower assembly and inlet cap. Gasket comes with blower. Read more

• Leaking

Replaced with new part ordered from store Read more

New element and gaskets Read more

I watched your repair video. Although not exactly like my freezer door the video provided me with enough information to complete the job in a matter of minutes. Read more

Disassembled washer, found that 2 out of the 3 basket support legs had cracked through. Unfortunately, support cannot be bought except as an assembly, so had to spend almost $300 for the part. Bearings were worn, but not trashed, so I replaced them and the seal. Note, most parts places (including AppliancePartsPros.com) will only sell the bearings and seal as part of the rear tub assembly. The bearings are standard 6205 and 6206 sealed ball bearings, available from Grainger and many others for... Read more

The fan was straightforward unscrew and disconnect wires then reinstall. The gaskets required the door to be disassembled contrary to the video that was provided when purchasing the gasket for the door. Disassembly was not hard just take a lot of pictures so you get everything back into the correct place. Also, a good time to clean door frame and wash the glass. Read more

We ordered all 3 replacement gaskets. My husband couldn't wait for them to sit and reach room temputature so we installed them right away. I used the hair dryer to take out a few wrinkles and they all fit great! Read more

Ordered new gasket and adhesive! Read more