Kenmore / Sears Hinge Parts

Watched your very helpful and informative "how to" video and replaced both right and left hinges. Getting the front panel to line up on the clips was the most difficult part. Read more

The plastic bearing broke after 7 years of too much opening and closing. Removing original bears were not real easy, however installing new ones were quick. It works well. The parts arrived really quickly. Read more

I removed the old hinges and replaced them with the new hinges. It was probably the easiest repair I've ever had to do. Read more

Replaced door closure and door stop. Read more

• Door won't close

Replaced the hinges after watching YouTube video. Read more

Replaced the hinge cam riser. As suggested I replaced hinge cam risers for both doors. Read more

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

I had to take out the bottom drawer that holds pans. Disconnect the power and pull the oven out. Removed door, rear panel that held the screws for the side panel and lift up and out the side panel. After that it was straight forward as to replacing the hinge. Spent more time cleaning the florr where the oven was than installing the hinge. Read more

• Door won't close

I replaced the hinges and hinge mounts. Upon inspection of the mounts, it seems that they had become slightly deformed on the lower portion, where the heel of the hinge applies pressure to the frame. Probably didn't need new springs, just the mounts, but I just kept em in anyway. Easy fix, anybody can do it, good instructions in the kit. Very pleased with appliancepartspro speed of delivery. Read more

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

• Door won't close

This oven was a Kenmore model #66595822003. I replaced both spring hinges. This oven was a white oven so it took the MFG# WP8053807 hinge (order two of them). They are the same hinge. No left or right. To get the door off the oven, open the door all the way open, I installed pins (preferably only 1/4" long) in the holes of both hinges. Then remove the spring steel retainers above old hinges in the oven frame. These holds hinges in place. Now close the door until hinge stops on pins. Lift up... Read more

Looked up parts on internet using diagrams, ordered parts, they arrived in 2 days and installed them. Read more

New Door Handle and the plastic spacers Read more