Kenmore / Sears Hinge Parts

We had to pry the door open with a crow bar. We then ordered a replacement hinge from your company. We were able to find the part by looking at your diagram of our oven. We ordered it and it came in two days. My husband put it on and the door now works beautifully. Read more

The left hinge works on the right side as well as the left. All you have to do is unscrew the little plastic post and move it to the other hole. So even though the web might say that the left hinge assembly is not compatible with your fridge, or that the right hinge assembly is no longer available, it will still work. The door stopper assembly worked just fine. All you have to do is screw it in to the bottom of the door. You will have to disassemble the top hinge (on top of the fridge) in... Read more

You guys had the exact hinges I needed and I was able to get the frig up and running shorty Read more

Replaced plastic cam on bottom of door. Read more

• Door won't open or close

The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more

Watched your very helpful and informative "how to" video and replaced both right and left hinges. Getting the front panel to line up on the clips was the most difficult part. Read more

Ordered the full hinge piece and an extra bushing. Was able just to slide the dishwasher forward a bit, lift the right side hinge off its seat and pop in the new bushing without disassembling. Fixed! I am retaining the full hinge piece in case of any future door incident but suspect I will never need it Read more

Replaced these parts Read more

I ordered the door stops (or door cams) for both the fridge and freezer and the hinge bearings. I figured I might as well do both if I'm going to do one. Very easy. Watched a YouTube video. Got a link to the site to order the parts. All you need is a screwdriver and ratchet. Done in 30 minutes. Read more

My Whirlpool refrigerator model GSS26C4XXF03 door wouldn’t swing shut all the way like it used to. So I changed the two lower cams. This cam #WPW10257203 was a perfect match but I needed to change the matching cam on the hinge, also, which require some modification to fit (I ordered cam #W11311687). The whole thing would have taken less than 15 minutes if I didn’t have to modify the other cam. Read more

The right door on our Jenn Air French Door Refrigerator would pop open & not fully close when the left door was closed first. Called the local distributor/dealer who advised me that the magnetic door gasket probably needed replacement (cost $300.00 + for the repair) What??? Visited you web site where I noted the right door had a "closure & bushing" on the bottom of the door. Could it be this was the problem fix? Took the right door off & examined both pieces. Sure enough the bushing was... Read more

Replaced the lower hinge. Read more

I made a lucky guess when I ordered the part as I had no model # or anything to go by. I just ordered what looked like the right thing and it was the exact part for my fridge. Replacement was easy. Read more

I replace the springs first. That wasn't the issue. Then I replaced the hinges. Boom! Problem solved. Read more