Kenmore / Sears Insulation, Sound Dampening Parts

Foam insulation recess for refrigerator interior. Replaces damaged, cracked, or missing insulation pieces in cabinet recesses and compartments.

Insulation foam that protects electrical components in your top-mount refrigerator. Replace if cracked, deteriorated, or missing to maintain proper coverage.

Acoustic foam pad that reduces refrigerator noise and vibration. Replace if original pad is torn, compressed, or missing for quieter operation.

This cushion is a small mounting pad that helps reduce vibration and cushions contact between moving or mating parts, improving fit and reducing noise. Use it to replace worn or missing cushions that allow rubbing, rattling, or uneven contact. What it does:

• Pads and isolates components to cut down on vibration and noise
• Prevents direct hard contact that can cause wear or chafing
• Helps maintain proper alignment between parts that bear weight or move
• Commonly used where a soft stop or spacer is needed to prevent rattling

• One cushion

• Inspect the mating surfaces and remove debris before installing the cushion
• Install in the same orientation as the original part; hand-press or gently tap into place
• Do not use adhesives or solvents unless specified by the equipment manufacturer

This cabinet insulation piece cushions and thermally insulates the refrigerator cavity to help maintain steady internal temperatures and reduce noise. Replaces compressed or damaged insulation to improve cooling efficiency and reduce condensation. What it does:

• Provides thermal barrier between cabinet and liner to help keep cold air in and reduce heat transfer
• Dampens vibration and reduces run-time noise from compressor and fans
• Helps limit frost buildup and interior moisture when insulation is damaged or missing
• Restores factory-fit padding and support around evaporator or cabinet openings

• Disconnect power before servicing and work on a cool appliance
• Remove outer panels or liner as required to access insulation; keep fasteners for reassembly
• Fit insulation into cavity, aligning edges and any adhesive/retainer locations; do not compress excessively
• Avoid contact with electrical components or sharp edges; replace any damaged retainers or seals