Kenmore / Sears Refrigerator Auger, Helix, Crusher

Ordered part and replaced in 10 minutes. Works great and if need future part I know where to go. Read more

My frig is a year and a half old, Frigidaire with french doors and freezer drawer. It has an upper ice maker for the door in the frig and a bottom ice maker in the freezer drawer. After noticing the flood, I shut off the water supply to the frig and cleaned up the mess. Didn't know if it was the water solenoid valve that stuck open or if the bottom ice maker got stuck calling for water. This frig has 4 solenoid valves and according to the schematic, two valves are active any time water is... Read more

Replacement tray from Appliance Parts Pro. Read more

This was a two and half year issue as different things failed at different times. I would get one part, then another would fail. Ultimately, I got to a point where what failed, I hadn't been ordered the part yet. The seal on the freezer door took three bathing's before it plumped up and un-creased. The directions on the box it is shipped in said to heat the seal up in hot water then cool it down with tap water. I didn't need to do that. It took a lot of massaging of the seal, but... Read more

Replaced the entire mechanism with a new one. Read more

Just slid it under the ice maker Read more

Simple fix purchased complete assembly slid old one out and new one in transferring ice was hardest part Read more

• Leaking

I have a Whirlpool Side-by-side Model ED22PWXBW01. A year ago, the ice cubes started freezing together in the rear of the ice bin for no apparent reason. Although the problem started off small, it gradually grew much worse, and finally I could see water dripping out of the ice mold and into the bin during the fill cycle. Re-levelling the refrig didn’t help, nor did adjusting the cube size / fill level. With guidance from the video, I removed the icemaker from the wall of the freezer. The... Read more

Replaced the ice level arm Read more

I replaced the auger motor. You have to remove complete ice maker. Everything is just like help video to do except yoke dispenser. I watched video several times. Yoke will not just tap loose, after 30 minutes of tapping, I was using screwdriver to brace. I used a Dremel tool to cut part of shaft, came off easy then. After that, the repair went great. I have ice, I noticed motor I received was stronger. Parts came on time stated and worked great. I will order again on other repairs. Read more

I ordered the bucket and it was on my door step the next afternoon, Read more

• Ice maker not making ice
• Leaking

Replaced it Read more

The drive blade has come off of the drum and the auger. When I try to dispense ice and the auger rotates, the drive blade does not rotate with it. Hence, the drive blade was not pushing ice into the drum (and into the ice crusher housing and dispense chute). Apparently, the hole of the drive blade was no longer "biting" the auger so that it will rotate with it. I did not know how to re-attach the drive blade back to the auger (short of welding it). So I ordered the Ice Container Assy. Took out... Read more

It was a snap. All I had to do was unsnap one end of where the ice tray attached to the ice maker and fit the tray into the two sides and then resnap the end back onto the icemaker. Very easy. Read more

Replaced the ice maker for the 2nd time in less than 4 years of owning the fridge. It's a super easy fix.......... remove one screw, unhook a wire harness and slide it out and then slide the new one in. Read more

• Ice maker dispenses too much ice

Item delivered to my door in 1 1/2 days, priced $40 below other sites I had checked. Installed in 15 minutes. Just know that when installing an ice maker they don't start to make ice immediately. It can take several hours Read more