Kenmore / Sears Refrigerator Drawer, Shelf, Pan

Looked at the provided video. PERFECT results. Read more

Ordered left and right side supports and they arrived in two days! It took me longer to get stuff out of the way in the fridge so I could take the shelf out than it did to actually swap out the side supports. Parts fit perfectly and quick easy repair. Read more

Ordered replacement drawer, new drawer was an exact replacement even though the part number had been changed. Read more

Pulled out storage bin Removed side track rail covers Popped off gear from holding clip Installed drive shaft Installed rail cover and storage bin Only took about 15 minutes Read more

Easy to replace with the shield and paddle assembly. Steps are: 1. use a flat head screwdriver to push the tabs at the base of the control panel. remove the wire connectors by gently prying them straight off. 2. remove the 4 phillips screws holding in the old assembly. 3. Install the new assembly by carefully putting the paddle behind the water pipe that sticks out. You may have to push the paddle one way to get it around the pipe and then back into place. 4. reinstall the screws. 5. reconnect... Read more

Yes exact fit Read more

No instructions are included with either piece, which makes installation take more time and care. Tools needed: Small standard flat blade screwdriver, box knife or other knife with at least a 2" long blade, super glue. Remove the old main crisper frame: 1. Remove old main frame by lifting upward and outward. 2. Remove the center rail from the frame. May require bending of the main frame to remove it. 3. Remove the crisper front panel by unsnapping from frame. This is easily done by... Read more

Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more

After sliding out the old shelf I removed the middle track from the old shelf & installed it with the new left side track on the new shelf. They basically click in & out. Slid the new shelf assembly in & put meat drawer in place. Read more

Right-side gasket replacement was straightforward. Left side required removal of mullion, which stumped me. I contacted Appliance Parts Pros who gave me the necessary instructions: Remove the center screw and lift up the mullion. Simple enough, once I knew how to do it. Read more

The manual had instructions for pulling things apart, the flaps over the drawer tops and the clear plastic inserts in the shelf. Flaps--Easiest to work with when the shelf is out and upside down. Slide flaps to the side a little to release the axle pin on the flaps from the receptacle hole on the shelf frame. Clear plastic plates are held in with a plastic pin on the side of the shelf frame. Carefully pull the side off the shelf there away from the pin slot until the insert pops out.... Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

Ordered and installed new ones. Read more

Ordered and installed new ones. Read more

Ordered part from appliancepartspros.com and got them within 2 days.that was great,refrigerator is like new again,am I am pleased with service and there swift delivery. If I need any thing else,there is only one place I will get them.from. Thanks! Read more

Used same tools as in your video. Read more