Kenmore / Sears Refrigerator Parts

Installed new ice maker. Had trouble finding the correct one but with the help of Appliance Parts Pros I was able to purchase the one that worked with the refrigerator. Read more

Put racks to together and put into fridge Read more

Put a new one on. Read more

Just put in the new piece No tools required Read more

• Leaking
• Not dispensing water

We noticed a puddle of water in front of the fridge a couple of months ago-dried the floor up both times and thought someone had dropped ice-or spilled water. A couple of weeks ago there was water dripping through the dropped tile ceiling in the basement. I shut off the water for the water supply to the fridge at the copper pipe in the basement and removed some of the tiles which felt a little damp. It still dripped all day. When my spouse came home he pulled down more of the tiles. It was as... Read more

Put racks to together and put into fridge Read more

Replaced door cam. Lower bracket to be ordered and needs replaced also. Will order today. Read more

• Not dispensing water
• Leaking
• Ice maker not making ice
• Ice maker won't dispense ice

To verify if you have a bad valve in the first place read on... I first pulled out the ice maker to remove all the frozen water including the inlet section which was a huge solid waterfall of ice. While it was out completely disconnected I cleaned/chipped out the freezer section ice puddle. I also completely melted the ice cubes and ice puddles off the ice maker at the fill bucket end in the sink with running water careful to not get water near the power cord area. I then put a tall plastic cup... Read more

• Not dispensing water

I watched the Appliance Parts Pros repair video and decided to remove the front panel to diagnose the problem. While the repair video is excellent, I could not remove the ice/water dispenser front panel with a putty knife. On my model, 106.56234400, there is no clip that can be released by sliding a putty knife up under the front panel. It took a little effort but I was able to pop the left lower corner clip just by pulling it out with my fingers. Once the cover was off I could see that the... Read more

• Door won't open or close

Replaced the lower hinge bearing and lower door cam on fridge side. Read more

Replaced the starter and capacitor, 30minutes, $60.... Bam!!! Fixed Read more

• Fridge runs too long
• Door sweating
• Door won't open or close

Replaced the lower auto close hinge. Used your web video as a guide. Read more

Purchased a new one from you. Viewed your youtube video to figure out how to do it. Read more

Replaced two crisper drawers and a door shelf. The person who took my order was helpful and thorough in determining what I needed. The company was equally helpful when I needed to return some parts that I ordered which I turned out to not need. Read more

I ordered the part from ApplianceParts Pro.com and could not believe how fast the part arrived. It arrived by FedX the very next day after I placed the order. The repair suggestions that was given on your web site was right on. The repair was so simple. I was thinking that I was going to disassemble the ice maker to access the connections but with the very simple guidance you provided, the repair took maybe a total of 20 minutes from start to finish. Awsome!!! Read more

Replaced both inlet valves, no joy. Upon further inspection, found ice maker harness extremely tight at lower freezer door hinge, clamped in place right at a pivot point. Essentially the harness is held in place and rotates with the door. 6 wires broken inside. Splice repair and ice maker now works. Most likely will have to replace harness eventually. Unless there is more slack inside the freezer door this will probably happen again. Very poor design. Read more