Kenmore / Sears Refrigerator Parts

Put racks to together and put into fridge Read more

Replaced the water inlet valve assembly. That reduced the leakage to a smaller amount but did not fully stop the leakage. Replaced the ice maker assembly and that completed the repair. No leakage issues and ice maker is working with no issues. Read more

• Door won't open or close

Replaced the lower hinge bearing and lower door cam on fridge side. Read more

• Fridge runs too long
• Door sweating
• Door won't open or close

Replaced the lower auto close hinge. Used your web video as a guide. Read more

Ordered the plastic glides that connect to the metal rails. Super easy fix! Read more

They just slide in place. One shelf was broken and I had to reorder. Received the replacement within 48 hours. Read more

Our Kenmore (Whirlpool) refrigerator's ice maker had stopped making ice. I searched YouTube and found a repair videos for this exact problem, finding one with a similar refrigerator and the identical ice maker. I learned that the Water Inlet Valve had likely gone bad and would need to be replaced. In the video the tech pointed out the small rubber tube inside the freezer that comes down from the ceiling of the refrigerator into the ice maker. This tube feeds it the water to make ice with and... Read more

We watched a "youtube" video on how to fix a fridge door seal and even though this particular model fridge was not the same...it helped to see how to fix it. It took me 20 minutes to remove and replace the new door seal. The part ordered was ordered and delivered next day which was great!! Read more

Put racks to together and put into fridge Read more

• Ice maker dispenses too much ice
• Ice maker not making ice

Replaced it very easily. Read more

I tried duct tape but then decided to buy the parts from Appliance Pro's and fix it correctly. It looks brand new now. Thank You :) Read more

Manufacturer no longer makes part, but found rough equivalent by searching AppliancePartsPros.com web site. Not exact fit, but excellent substitution. Simple replacement of shelf on existing bracket. Read more

I removed the meat drawer and shelving unit. I unscrewed the Philips head screws on either side of the shelf brackets. I cleaned the old surfaces and fitted the new plastic hangers in place. I screwed the new hangers in place with the screws I had from the old ones. It was very easy, except the holes in the plastic hanger are not quiet big enough for the screws. I had to push very hard with the screwdriver, and started to strip the head of the screw as well at the screwdriver itself. I did... Read more

Bought replacement drawer Read more

• Not dispensing water
• Leaking
• Ice maker not making ice
• Ice maker won't dispense ice

To verify if you have a bad valve in the first place read on... I first pulled out the ice maker to remove all the frozen water including the inlet section which was a huge solid waterfall of ice. While it was out completely disconnected I cleaned/chipped out the freezer section ice puddle. I also completely melted the ice cubes and ice puddles off the ice maker at the fill bucket end in the sink with running water careful to not get water near the power cord area. I then put a tall plastic cup... Read more

• Not dispensing water

I watched the Appliance Parts Pros repair video and decided to remove the front panel to diagnose the problem. While the repair video is excellent, I could not remove the ice/water dispenser front panel with a putty knife. On my model, 106.56234400, there is no clip that can be released by sliding a putty knife up under the front panel. It took a little effort but I was able to pop the left lower corner clip just by pulling it out with my fingers. Once the cover was off I could see that the... Read more