Kenmore / Sears Wire, Harness, Power Cord

This wiring harness connects the control panel to the oven's main control, delivering power and signal paths so the console and electronic controls operate correctly. It restores reliable button, display, and control communication when the harness is damaged. What it does:

• Routes power and signal lines between the control/console and main control board
• Replaces frayed, burned, or interrupted wires that cause unresponsive buttons or intermittent control behavior
• Helps restore normal display illumination and keypad response when the original harness is faulty
• Maintains proper connector fit and strain relief to prevent shorts or loose connections

• One wiring harness for the control panel

• Disconnect power to the appliance before beginning any repair to avoid shock or injury
• Document or photograph wiring locations before removal to ensure correct reinstallation
• Handle connectors by the housings; avoid pulling on wires to prevent damage
• After installation, restore power and test all control functions before reassembling outer panels

This main wiring harness connects the appliance's control components and power distribution, restoring electrical pathways so controls, sensors, and motors can operate correctly. Replace a damaged harness to regain reliable electrical continuity and signal routing. What it does

• Routes power and control signals between the appliance control board, switches, sensors, and motors.
• Restores electrical continuity when broken, cracked, or melted wires cause intermittent or no operation.
• Helps eliminate faults caused by shorted or corroded connector pins and damaged insulation.
• Supports normal operation of the user interface and protected components by keeping wiring organized and secured.

• One main wiring harness assembly as pictured.

• Disconnect power (unplug or switch off breaker) before starting any repair to avoid shock or equipment damage.
• Verify the harness matches the connector types and mounting points on your appliance before installation.
• Use proper strain relief and routing to avoid pinched wires; replace any damaged clips or grommets.