Kitchenaid Cap Or Cover

Trim cover cap for refrigerators. Installs on exterior panels to conceal screws and provide a finished look. Replace if cracked, broken, or missing.

Plastic cover that conceals the top hinge assembly on your refrigerator door. Replace if cracked, broken, or missing to restore a clean appearance.

White plastic corner cover cap for refrigerators. Replaces cracked, broken, or missing corner trim pieces. Snaps into place on cabinet corners.

Plastic cover that conceals the top door hinge on your refrigerator. Replaces cracked, broken, or missing hinge covers for a clean finished look.

Plastic cover that shields the water inlet valve assembly on the back of your refrigerator. Replace if cracked, broken, or missing to protect wiring.

The left hinge cover assembly is the decorative plastic cap that snaps over the upper or lower left door hinge on your refrigerator, concealing the hinge hardware for a clean finished look. It also helps protect the hinge mechanism from dust and damage. Replace this part if the existing cover is cracked, broken, or has gone missing, leaving the hinge hardware exposed.

Color: Apollo Gray

Protective cover for the high voltage control unit in your refrigerator. Replace if cracked, broken, or missing to protect electrical components.

Grey right-hand hinge cover cap for bottom-mount refrigerators. Replace your cracked, broken, or missing hinge cover to restore a clean appearance.

Replacement access panel cover for side-by-side refrigerators. Encloses internal wiring and components. Needed when original is cracked or missing.

This plastic filter cover protects the dishwasher's filter and sump, helping keep food and debris out of the pump while directing wash water through the filter area for proper draining and cleaning performance. What it does:

• Covers and secures the filter/sump area so debris is trapped before reaching the pump
• Helps channel wash water through the filter for effective filtering and draining
• Reduces risk of pump clogs and noisy operation from loose debris
• Commonly replaced when cracked, warped, or not seating properly which can cause poor draining or food re-deposit

• Disconnect power to the appliance before performing any service
• Remove the lower rack and lift out the filter assembly to access the cover
• Inspect and clean the filter and sump area before installing the new cover
• Refer to the appliance's diagram for correct orientation and fastening

Protective cover for water valves and inlet hoses. Replace if cracked, broken, or missing to shield components from debris and accidental contact.

Secures and seals the water filter in its housing. Replace if cracked, broken, or missing to restore a proper fit after filter changes.