Magic Chef Parts

Appeared to be two problems: the latch was worn and one of the pins that slid in a guide on the actuator located in the inner panel had broke off. Detergent lid spring and pin appeared to be OK but decided to replace since I was aready working on it. I ordered all the inner panel mechanism from the control arm to the latch actuator on the inner panel. The repair was successful as the detergent dispenser now opens during its cycle. Read more

• Won't start
• Door latch failure

Discovered that the common cause of the problem was the latch in the door. Found a video online that showed the exact procedure for my model dishwasher. Ordered the part from AppliancePartsPros on a Thursday afternoon and it was in my hands by noon on Friday. Carefully took the door apart, compared parts, reassembled, and the joy on my wife's face was priceless when the dishwasher started up without doing anything special. Do not be afraid to attempt this repair. Read more

Water dispenser came down to a trickle and made a lot of noise, I changed the filter but it didnt help and thus the water tank/head assembly needed to be replaced. Replacing the water Tank/head assembly was an easy task, the hardest part is removing the covers and taking care of not breaking the insulation of the water inlet hose. For the not-so-experts like me it is also good to rememebr to have a bucket to collect all the water that comes out after the connection to the solenoid valves is... Read more

I watched the video on your site and it showed step by step how to replace the spring. Excellent shipping time. Good customer service on chat forum. Read more

I knew for sure that the hinge with the large spring was damaged, but elected to replace both hinges and receivers. Replacing the parts was fairly easy and would have taken me less then an hour. This model has thin metal covers over the hinge assemblies. I found that squeezing in the sides of the covers help to hold them in place on the hinge while reassembling the door. My only difficulty was putting the door back on the oven. It took a little maneuvering but I managed to get it. Now the door... Read more

• Will not tumble

Replaced the tension pulley assembly, drum rollers, drum roller axles, belt, and drum glides while I had the dryer disassembled. It turned out that the cause of the squeak was the tension pulley assembly, however it was easy and economical enough to replace anything that could have been the cause of the squeaking while I had the dryer apart. The parts were ordered on Thursday afternoon and delivered on Friday. I had the dryer repaired and running like new in no time. For about $100, it was... Read more

All the corners of the Ice Bucket were cracked and was causing the screw inside the bucket to jam. Read more

• Freezer not defrosting
• Fridge runs too long

Put in a new part Read more

Replaced the heater, timer, and wiring harness Read more

Normally when you let go of the dishwasher door partly open it would stay in that position. But lately when you let go of the door it would fall to the fully open position. Turns out this little cable was broken one one side. Just puss the dishwasher slightly out of the cabinet and you can replace the cable in minutes. It is just held in place with a spring. Read more

Ordered a new one from Appliance Parts Pros.Fast delivery and a great price on the handle. Read more

Replaced the hinge receiver with a new one. The old one was bent slightly inside where it could not be seen. I think someone pushed the door down to far or fell on it. 2 screws to remove it, take out storage drawer and reach up little ways to remove and replace the receiver. Replace the 2 screws. The receiver comes with 2 screws but I ordered an extra ( never used it ). The sides of the receiver were spread just a tiny bit but were enough to cause a problem. Read more

Replaced refrigerator thermostat that I purchased from Appliance parts pros and now working like brand new. Read more

Ordered part and installed it. Broiler works as advertised. Read more

Replaced icemaker and shutoff arm. Easy project. Read more

Replaced light switch. That did not work, problem was in led lights. Read more