Maytag Agitator Parts

Slipped old one off slipped new one on Read more

Very easy fix! Order shipped fast and received the item in a couple of days with a 10 minute fix! The step by step video helped most! Thank you so much for this website as it probably would of cost me at least $125 to fix! Read more

I watched the Youtube video from AppliancePartsPros.com, bought the agitator kit, rewatched the video, installed the parts, washing machine working like new. Phenomenal. Read more

I replaced the entire agitator (my appliance agitator could only be replaced in one part not the upper part only). It was super easy but one thing....the video on the website was not helpful because my maytag washer is older and does NOT have a screw down inside the agitator but has one 1/4 inch hex nut on the side down by the base. Good for me though because all I had to do was unscrew the nut, put the new agitator on, tighten the new nut and DONE!! Read more

It was fairly simple, unbolted the agitator and pulled the old one out then put in the new...although when when a load became unbalanced the rocking motion slowly strips the bolt, I would suggest if replacing this unit also order the bolt. I also bought loctite dew to the fact that the bolt was stripped. Read more

By watching your video and following the instructions Read more

I had replaced the Agitator cams a couple of times already due to my brother-in-law overloading the machine which stripped the teeth off of the cams. I also noticed the agitator seemed to 'wobble' and made 'knocking' noises quite a bit. I reviewed the video on the Appliance Parts Pros web site, disassembled the agitator and cleaned everything up, which helped a little, but not enough. Figuring the agitator itself was worn out also, I looked up and ordered all the parts for the upper agitator on... Read more

A buddy of mine gave me a washer and said if you can fix it you can have it, It doesn't spin. I tried running a spin cycle and found that it did try to spin but was very noisy. I disassembled the washing machine and found that the tub seal had gone out and took out the bearings with it so I ordered a new tub and seal kit and while I waited for that I proceeded to disassemble the rest of the washing machine and clean everything so when the new parts arrived it was ready and waiting. Bearing... Read more

My wife noticed that our washing machine was making a terrible rumbling noise and seemed to be out of balance all of the time. She was on the verge of calling a repairman when I said I wanted to look at it first. I noticed the agitator was very loose and would spin in your hand. I removed 1 bolt and the agitator was out. The teeth in the agitator were stripped out so by simply ordering a new agitator and installing it I turned a $250.00 repair call into a $70.00 DIY fix. Thanks. Read more

I replaced the washer plate and new screw/washer part. Easy fix and back up and running in ubder 10 minutes. Read more

Replaced top part of agitator and agitator dogs. Repair video very helpful. Read more

Replaced agitator and wash plate. Read more

There was a single bolt through the bottom of the agitator that connected it to the tub. Undoing the bolt to remove the broken base of the old agitator, placing the bolt in the base of the new agitator, aligning and tightening the bolt. Read more

The plastic ridges on the inside of the washplate were stripped. New washplate solved the problem. This washer is barely 3 years old, so I guess I can expect to be doing this again, but better than buying a new washer. Read more