Maytag Washer Switch

Fix unresponsive or erratic cycle selection with this rotary encoder switch. Mounts behind the control knob to restore accurate cycle settings and indicators.

If your washer won't fill, overfills, or leaks water everywhere, the water level pressure switch may have failed. DIY fix in 15 minutes or less.

This rotary on/off switch controls the dryer's Finish Guard (also called Wrinkle Guard/Wrinkle Shield) feature. Replacing it restores proper control of the post-cycle intermittent tumbling that helps reduce wrinkles, preventing the feature from being stuck on or off.

• Provides 2-position on/off selection for the Finish Guard/Wrinkle Guard function
• Failure can cause the feature not to engage or to stay on after the cycle ends
• Knob may feel loose or fail to click when the switch is worn
• Mounts in the control console and interfaces with the external selector knob

• Disconnect power before servicing
• Access through the control console; remove paneling as needed
• Transfer wires one at a time or photograph connections for reference
• Reinstall using the existing knob and mounting hardware

Washer won't spin or stops mid-cycle? This tub displacement switch senses water level and balance to restore proper spin operation. DIY-friendly fix.

This Smart ATC temperature switch senses and helps regulate oven temperature for more consistent cooking. It replaces a failed switch to restore correct temperature feedback to the range control for accurate heating. What it does:

• Detects oven temperature and sends a signal to the control so heating elements cycle appropriately
• Helps correct issues where the oven runs too hot, too cold, or cycles erratically
• Works as part of the temperature control system—does not include the main control board
• Replaces a worn or failed temperature/A.T.C. sensor switch to restore proper temperature sensing

• One temperature switch (Smart ATC)

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Access typically requires removing the oven control panel or back panel; keep track of screws and wire connections
• Handle the switch and connector gently to avoid damage; verify wiring matches original before reconnecting

Washer won't start or stops mid-cycle? This dual lid switch kit restores safety interlock function. Moderate DIY repair in 30-45 minutes.

Fixes washer that won't agitate, spin, or start. If your washer stops mid-cycle or won't run with lid closed, this lid switch kit restores operation.

Color: Black. Instruction sheet included.

Fix an oven that won't switch between bake and broil modes with this rotary selector switch. Controls oven functions and temperature selection reliably.

This cycle selector switch is the user control that selects and advances cooking/drying cycles, restoring reliable cycle selection and user control on compatible appliances. It provides a direct replacement for a worn or non-responsive selector. What it does:

• Rotates to select the appliance cycle and sends the chosen setting to the control system
• Restores proper cycle selection when the knob or control no longer changes settings
• Commonly used when cycles won't start, don't advance, or the control feels loose or intermittent
• Works as the mechanical/electrical interface between the user knob and the appliance control

• Disconnect power to the appliance before beginning any work
• Remove the control knob and panel trim to access the switch—keep track of screws and small parts
• Note or label wire locations before disconnecting; reconnect wires to the same terminals
• Test cycle selection and appliance operation after installation; if issues remain, check related controls and wiring

Fix a washer that won't fill properly or overfills with this water level pressure switch. Controls fill cycles based on load size. DIY repair.

Fix a washer that won't select the right water temperature or cycles with cold water only. This temperature switch restores proper cycle control.

Washer won't spin or agitate? A faulty lid switch may be preventing your washer from starting the cycle. This switch replacement takes 15-30 minutes.