Range / Cooktop / Oven Switch

This burner box wiring harness connects the cooktop/oven burner components to the appliance's control systems, restoring reliable ignition and power routing for the burner box area. Use to replace a damaged or burnt harness for safer operation. What it does

• Routes electrical connections between igniters, sensors, switches, and control modules in the burner box
• Restores ignition or heating when a frayed or open harness prevents burners from sparking or heating
• Replaces harnesses with cracked insulation or melted connectors that can cause intermittent operation or arcing
• Helps eliminate electrical shorts and poor contact at connector plugs inside the burner box

• One burner box wiring harness as shown

• Disconnect all power (electrical and gas) before servicing; verify power is off
• Inspect connectors and routing in the burner box, replacing any mounting clips or fasteners if damaged
• Ensure correct connector seating and secure wiring away from high-heat components

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

If your range burner won't heat, stays on high, or won't turn off, the infinite switch controls temperature. This part regulates surface element power.

If your range burner won't heat or stays on high, the infinite switch likely failed. This control regulates surface element temperature levels.

Fix a burner that won't heat or won't turn off with this cooktop burner control switch. Most DIYers complete this repair in under 30 minutes.

This is a small electronic switch that controls an LED indicator light on the range control panel. It signals when a burner or element is active by illuminating the corresponding indicator. Replace this switch if the indicator light no longer turns on or stays lit continuously regardless of burner status.

Burner won't change heat settings or stays on one temperature? This infinite switch restores adjustable control to your range's surface elements.

This fan relay is an electrical replacement part that restores the relay control for the refrigerator/freezer fan motor so the appliance can circulate air properly and maintain even cooling. Use it to replace a failed relay and return fan operation. What it does:

• Switches electrical power to the evaporator/condenser fan motor when the control calls for airflow
• Commonly used when the fan won't start, runs intermittently, or the appliance struggles to maintain temperature
• Helps stop clicking or repeated start attempts caused by a bad relay
• Works as the control interface between the main control and the fan motor

• One fan relay

• Always unplug the appliance before starting any repair to avoid shock risk
• Locate the relay on the compressor or control module per your model's service guide and note connector positions before removal
• Transfer wiring/plug connectors exactly; avoid bending pins or over-tightening fasteners

Replace a faulty range igniter switch when burners won't light or spark inconsistently. This switch controls the spark ignition system for gas burners.