Range Hood Parts

This ballast transformer restores proper power regulation to the appliance lighting circuit so bulbs operate reliably and safely. Designed for use as a direct replacement to revive dim, flickering, or non-working range-hood/vent hood lamps. What it does:

• Regulates voltage to the appliance lighting system so lamps start and run consistently
• Helps eliminate dimming, flicker, or intermittent light failures tied to a faulty ballast
• Works with the hood's existing lamp sockets and wiring to restore normal lighting operation
• Supports service-level replacement where the original ballast has failed

• Service-replacement part — disconnect power to the appliance before starting work
• Handle carefully to avoid damage to terminals; secure mounting per original hardware

Replace a worn, cracked, or missing control knob on your range hood. Restores precise setting selection and completes the control panel interface.

Replacement vent flap for range hood duct systems. Installs in exhaust duct to prevent backflow and outdoor air entry. Needed when missing or damaged.

Duct connector that routes exhaust air from your range hood to the venting system. Replace if cracked, damaged, or missing to restore proper airflow.

This is a 30-inch decorative trim piece designed for a built-in range or oven. It provides a finished appearance along the front edge or frame of the cooking appliance, covering gaps between the unit and surrounding cabinetry. Replace this trim if it is cracked, warped, discolored, or missing, which can detract from the appearance and proper fit of the appliance.

Exterior trim panel that secures and conceals the filter assembly on your range hood. Replace if cracked, broken, or missing to restore a finished look.

Blower not working or stuck on one speed? This range hood blower switch restores proper fan speed control. Direct replacement for worn control switches.

Fix a range hood that stops working intermittently or won't turn on at all. This control board resolves power issues affecting fan and light operation.

This is a container or receptacle assembly used to house and organize wiring connections within a range vent hood. It protects electrical terminals and wire harness connections from damage and ensures secure contact. Replace this part if wiring connections are loose, corroded, or if the hood's electrical components are intermittently failing.

This is a short wire jumper used in range vent hoods to connect electrical components or bridge circuits on the control board. It ensures proper electrical continuity between internal connections. Replace this wire if you notice intermittent fan or light operation, or if the existing jumper wire is corroded, broken, or burnt.

Nickel-plated dome plug cap for range hood housing. Replaces cracked, missing, or worn decorative plugs. Installs on ventilation cover assembly.

This is a small support piece that holds the interior shelf or turntable tray in place inside the microwave. It provides a stable resting point so the shelf sits level during operation. Replace this part if your microwave shelf wobbles, tilts, or no longer stays in position.

Hanger bracket assembly for range hood installation. Secures hood to wall or cabinet. Replace if bent, cracked, or missing for proper mounting support.

Replacement damper for range hood ventilation systems. Installs in duct to prevent backdrafts. Order when original is cracked, broken, or missing.