Refrigerator Dispenser Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W10133603
Replaces a cracked, worn, or unresponsive dispenser pad on your refrigerator door. Installs in the front dispenser housing for water and ice.
Do-It-Yourself Stories from Customers like You
Water pad on refrigerator worked only when you pushed very hard on one 1/4" x 1/2" spot David P. • Hoover , AL • June 22, 2019
Removed water catcher, then 4 screws in water/ice vault in door, then removed screws on door side (5) top (2) and bottom (2). Removed stainless door skin.
Removed 4 hex head bolts in ice/water vault (containing pads) and 4 bolts on the module immediately above the vault. Pulled the vault and module above out part way to unplug one cable. Then laid on table to unplug pads. From back, each pad has a small indent preventing the pad from being pushed up and removed. Push the small indent with a...
Read more
More
$219.95
- Compare At:
-
$263.94
- You Save:
-
$43.99
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2206671B
Color: black. Measures about 9 inches wide by 2-1/2 inches deep.
Do-It-Yourself Stories from Customers like You
Stopped dispensing water Cristopher C. • Santa Rosa , CA • July 15, 2016
Ordered the parts. Watched a great video on this web site. Installed. Fixed. Easy peesey.
Read more
More
$51.95
- Compare At:
-
$61.82
- You Save:
-
$9.87
Genuine Frigidaire part
By: Frigidaire
Part Number: 240570236
Replace cracked or peeling dispenser cover label. Easy DIY fix—peels off like a sticker, alcohol wipe surface, press new label on. 10-minute repair.
Do-It-Yourself Stories from Customers like You
The label had cracked Charles R. • Elberton , GA • January 18, 2016
Removed old label, took the glue residue off, wiped it down with rubbing alcohol then attached the new label on to the fridge.
Read more
More
$23.95
- Compare At:
-
$28.26
- You Save:
-
$4.31
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10185233
Connects the dispenser motor to the ice bucket auger. Replace if stripped, worn, or broken to restore proper torque transfer and smooth ice dispensing.
Do-It-Yourself Stories from Customers like You
Paddle in ice/water despenser was pulled in the wrong direction and broken off William A. • Dumfries , VA • November 14, 2015
Removed drip pan from ice dispenser. Removed two screws hidden behind drip pan to loosen bezel at bottom. Carefully lifted bezel off top hook to expose controller board cabling. Disconnected three connectors to control board behind bezel to remove bezel completely. Removed two (possibly three) screws to access the back of the ice chute mechanism. Removed broken paddle that just snaps in, being careful to capture paddle spring. Put paddle spring on new paddle and maneuvered spring-end...
Read more
More
$50.43
- Compare At:
-
$60.01
- You Save:
-
$9.58
Genuine Frigidaire part
By: Frigidaire
Part Number: 241681901
Replaces a cracked, broken, or worn ice dispenser lever on your refrigerator freezer door. Press this actuator with your glass to release ice.
Do-It-Yourself Stories from Customers like You
Broken tab on ice actuator no ice dispensing Michelle R. • Discovery Bay , CA • September 05, 2015
A friend's ice dispenser was not working so I told them I'd see what I could find on the forum. Originally I thought the micro switch had gone out. When I received the part and went to replace it I found that the little plastic tab that engages the micro switch was actually broken off on the Ice Actuator. I returned the switch and got the correct part. It arrived in a couple of days. It took about 15 minutes to replace. Everything is working great now. The repair was pretty easy to do. I found...
Read more
More
$65.24
- Compare At:
-
$78.29
- You Save:
-
$13.05
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304493021
Replacement actuator arms for refrigerator ice and water dispensers. Includes both paddles. Needed when arms are broken, cracked, or missing.
Do-It-Yourself Stories from Customers like You
Ice acuator tab broke off Daniel S. • Chesterfield , MI • March 22, 2015
Took water and ice panel apart and replaced actuator with new one. took about 15 minutes. very easy fix!
Read more
More
$59.95
- Compare At:
-
$71.34
- You Save:
-
$11.39
Genuine Frigidaire part
By: Frigidaire
Part Number: 240570235
The refrigerator dispenser module overlay is an OEM part for Frigidaire refrigerators. This overlay sits atop the dispenser module providing additional protection and aesthetic appeal.
Symptoms of a bad dispenser overlay include:
- Cracks or breaks exposing underlying parts
- Misalignment or looseness within the refrigerator
- Discoloration or wear affecting appearance
- Inability to fully or securely cover the dispenser module
Causes of a bad overlay can include damage from impact, repeated opening and closing of the refrigerator door, or general wear over time.
This Frigidaire OEM part is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.
Do-It-Yourself Stories from Customers like You
Water dispenser cover was cracked Kristin H. • Woodridge , IL • January 06, 2025
Removed the old cover and replaced it with the new cover and label.
Read more
More
$26.95
- Compare At:
-
$32.07
- You Save:
-
$5.12
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10309866
This ice dispenser solenoid assembly engages the dispenser mechanism to switch between crushed and cubed ice. A worn or failed solenoid can prevent the selector from changing modes or stop ice from dispensing smoothly.
- Actuates the ice bucket/crusher selector to allow cubed or crushed ice
- Failure may cause only one ice option to work, no change between modes, or intermittent dispensing
- Can resolve loud clicking/buzzing from the dispenser area when switching options
- Helps restore proper ice dispensing performance
What's included: One ice dispenser solenoid assembly Install notes:
- Disconnect power before servicing the dispenser area
- Access is typically through the freezer door dispenser chute/ice bucket area
- Note actuator linkage orientation during removal to ensure correct reassembly
- After installation, test both crushed and cubed selections
More
$102.95
- Compare At:
-
$123.54
- You Save:
-
$20.59
Genuine Ge part
By: Ge
Part Number: WR62X107
Door solenoid with plunger.
Do-It-Yourself Stories from Customers like You
When dispensing ice from the ice maker, the solenoid was buzzing loudly. It was also rusting badly. Brian B. • Hudson , NH • March 28, 2014
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside....
Read more
More
$72.38
- Compare At:
-
$86.13
- You Save:
-
$13.75
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10353552
Forms the interior of your refrigerator's ice and water dispensing area. Replace if cracked, broken, or causing drips and frost buildup at the chute.
Do-It-Yourself Stories from Customers like You
Ice chute door not closing all the way so water was leaking from the ice melting. Robert F. • Sun City , CA • August 31, 2023
I bought the complete ice chute. It was easy to install and it works perfectly now. Many thanks.
Read more
More
$111.95
- Compare At:
-
$132.10
- You Save:
-
$20.15
Genuine Frigidaire part
By: Frigidaire
Part Number: 240434401
Replace your refrigerator's water filter cup if cracked, leaking, or frozen. Protects the filter and prevents leaks. Verify fit with your model number.
Do-It-Yourself Stories from Customers like You
Water cup frozen & cracked do to - 35 Mike T. • Greensburg , IN • March 12, 2014
Replaced cup & housing
Read more
More
$60.95
- Compare At:
-
$72.53
- You Save:
-
$11.58
Genuine Frigidaire part
By: Frigidaire
Part Number: 241947003
Replacement drip tray that sits beneath your refrigerator's ice and water dispenser. Catches drips and spills to keep the area clean and dry.
Do-It-Yourself Stories from Customers like You
The old part got scratch up pretty bad so i replaced drip tray i bought 2 will save for later Robert T. • Missouri City , TX • February 14, 2015
Opened package removed the old one and put in the new one you do not need any tools.
Read more
More
$33.95
- Compare At:
-
$40.40
- You Save:
-
$6.45
Genuine Frigidaire part
By: Frigidaire
Part Number: 242176503
Catches drips and splashes at the base of your refrigerator's ice and water dispenser. Replace this tray if it's cracked, broken, or missing.
Do-It-Yourself Stories from Customers like You
Wheel in crisper drawer broke free. Charles H. • Kissimmee , FL • May 06, 2023
Bought a new cover w/frame for the crisper drawer.
Read more
More
$79.53
- Compare At:
-
$94.64
- You Save:
-
$15.11
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2180325
Color: black. It measures about 9 inches wide by 4-1/2 inches deep.
Do-It-Yourself Stories from Customers like You
Missing a grille and broken cover Adrian C. • Hilton Head Island , SC • December 09, 2018
Ordered the parts and simply fit them in place.
Read more
More
$55.95
- Compare At:
-
$66.58
- You Save:
-
$10.63
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10397394
Black grille that sits at the base of your refrigerator's ice/water dispenser to catch drips. Replace when cracked, stained, loose, or missing.
Do-It-Yourself Stories from Customers like You
Missing overflow grille. Elizabeth G. • Palm Bay , FL • July 23, 2019
Bought a replacement overflow grille.
Read more
More
$44.25
- Compare At:
-
$52.66
- You Save:
-
$8.41
Genuine Samsung part
By: Samsung
Part Number: DA97-12088R
The Refrigerator Dispenser Cover Assembly is an essential component for maintaining the sleek appearance and functionality of your Samsung refrigerator. Designed to seamlessly integrate with a variety of Samsung models, this genuine OEM part ensures a perfect fit and reliable performance. The cover assembly protects the dispenser area from spills and debris, helping to keep your refrigerator clean and hygienic. Its durable construction withstands daily use, ensuring long-lasting protection and maintaining the aesthetic of your appliance. Installing the Refrigerator Dispenser Cover Assembly is straightforward, allowing you to restore your fridgeGÇÖs original look without any hassle. By choosing this genuine OEM part, you benefit from quality craftsmanship and compatibility, ensuring that your Samsung refrigerator continues to operate smoothly and efficiently. Whether you need to replace a damaged cover or upgrade your dispenser area, this cover assembly offers a practical and stylish solution, enhancing your overall kitchen experience.
Do-It-Yourself Stories from Customers like You
Ice/water dispenser paddle broke off Mark D. • Naples , FL • December 26, 2016
We used the AP5306646 Assembly Cover part to replace the dispenser portion of the unit. There is a video on YouTube where the person explains how to get the old unit out. It was 1 screw and then a pulling motion. It takes a little bit of strength and finesse but it came out like the video. Be careful unhinging the wiring harness from the main control unit, you definitely do not want to cut or break any of the wires on either side. Use small fingers to squeeze the clip's release hinge.
Getting...
Read more
More
$238.95
- Compare At:
-
$284.35
- You Save:
-
$45.40