Need Help?
Call
Oven won't ignite, slow to heat, or gas smell before lighting? This range igniter starts gas combustion. Takes about 15 minutes to install DIY.
Troubleshot the oven by checking the broiler which worked good (same fuel valve). After reading the some tips about troubleshooting the Glow Ignitor I could see the broiler ignitor got white hot and the oven ignitor only got bright orange (orange to red causes intermittent ignition or mini explosions). Watched the how to video and it was good information. You should be observant about which openings in the back of the oven as to where the two wires are coming out of. My oven is over 12 years... Read more
Fix burners that won't light or click continuously. This igniter electrode sparks to light gas burners. Easy 5-10 minute repair with a screwdriver.
Did some research to find out it was the electrode. Pulled out the old one to match what was on your site. It came in no time at all, and the replacement was a cinch. Read more
Fix an oven that won't heat or takes too long to reach temperature. This igniter glowbar opens the gas valve to ignite the burner. DIY-friendly repair.
Replaced the igniter Read more
Fix a gas burner that won't light or keeps clicking constantly. This spark electrode ignites your burner. Easy 15-minute DIY repair for most ranges.
Replaced spark module and all electrodes/igniters. Read more
The Ignitor is an OEM replacement part for Frigidaire gas ranges. Located near the burner heads, this component is responsible for generating the electric spark required to light stove top burners. Symptoms of a faulty ignitor include:
Causes of ignitor failure can be an accumulation of deposits over many heating cycles. Physical damage from pots/pans is also possible. As electrical parts, ignitors have a limited lifespan depending on range usage.
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Removed the bottom tin work in the oven and removed the burner tube. Tried to remove the igniter bracket but the screws were too tight for the Phillips head and couldn't get vice grips to clamp on the head, so I bent the bracket enough to remove and replace the igniter. Then reassembled. I give AppliancePros.com a 5 star rating. Site was easy to use, the part was delivered in under 2 days, and it was the correct part packaged carefully so the igniter was protected from breaking. Read more
This oven igniter lights the gas burner when the control calls for heat, restoring reliable ignition and consistent baking performance. Replace it if the oven won't light, preheats slowly, or the flame won't stay on. What it does:
Replaced igniter Read more
Fix an oven that won't heat, heats slowly, or fails to reach temperature with this bake igniter. Most DIYers complete this repair in 20-30 minutes.
Replaced ingniter. Unlike some of the repair videos I saw, I could do everything by removing the lower draw, and in fact access from the back of the stove was not an option on my Amana. Pulling the stove out and fussing around turned a likely ten minute job in to a twenty minute. Unit work great, now I just need to keep tabs on the broiler igniter, which may be on the way out as well. Read more
Fix burners that won't light or spark continuously with this gas range burner igniter electrode. Solves clicking, weak spark, or no-ignition issues.
We replaced both front orifice holders. Very easy to bend and break. If it has a deep bend in it, It will slow down the gas flow to the burner. if you have a low gas flow your burner will burn low So check your small silver gas lines and if you smell gas check your lines Read more
Burner won't spark or ignite? This cooktop igniter electrode creates the spark needed to light gas burners. Simple DIY fix in under 30 minutes.
This is a Montgomery Ward gas range made by Tappan. Parts are no longer offered for this appliance. So, I had to eyeball various ignitors to determine which one would work. I settled on the least expensive one and ordered two (Just in case there were "issues"). The parts arrived quickly but were not a simple drop-in replacement. The new ones were longer and smaller in diameter. I had to use the original bracket because it provided the electrical ground for the spark. I used a spring to... Read more
The Spark Igniter is an OEM replacement part for Whirlpool gas ranges. Located inside the oven cavity it initiates combustion using high-voltage electricity. This is a broil igniter for the upper (broil) burner. Causes of malfunction relate primarily to element degradation from extended heating cycles. Exposure to grease or other residue accumulation shortens the service life by insulating the hot surface. Symptoms involve:
This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.
Called a repairman and he told us we needed to change a bunch of parts and would cost over $400! Decided to do some research online and found suggestions to replace the spark igniter. Decided to give it a try. Took about 10min to replace and oven is now working perfectly, for a total of $30! Read more
Oven won't ignite or clicks but doesn't light? This bake burner with spark igniter fixes grounding issues and ignition failures. Easy DIY repair.
Replaced igniter under oven floor panel. Read more
Fix a gas burner that won't light or produces weak sparks. This cooktop igniter creates the spark needed to ignite your gas burner. DIY-friendly repair.
The igniter was sparking, but the spark did not appear as bright as the other burners. Swapped the burner and lid since that is where contact is made. Did not help. Came to the conclusion it was a faulty igniter. I ordered parts, replaced the igniter and now the range burner works fine. Read more
Oven won't heat or takes forever to reach temperature? A weak or failing igniter is the likely cause. This range oven igniter is a 10-minute DIY fix.
I replaced the igniter with a Frigidaire(Electrolux) part. The small oven on my Thermador Pro-Harmony Gas Range stopped heating (on Thanksgiving Day of course). I looked on the internet and I saw a video indicating it may be the igniter. I ordered both the Bosch igniter (00415504) and the Frigidaire (5303935066). Bosch and Thermador are the same company. The Bosch igniter looked like the existing Thermador except the connecting wires were too short. Therefore I used the Frigidaire/Electrolux... Read more
Burner won't light when you turn the knob? This spark electrode creates the electric arc that ignites your gas burner. Straightforward DIY repair.
Replaced Read more
Fix burners that click but won't light with this gas range surface burner igniter. DIY-friendly repair takes about 10 minutes with basic tools.
First I watched the repair video, and then was successful in changing out two of the Ignitor's on the surface Burners, it worked great ! Read more
Burner won't light or takes multiple attempts? This gas range igniter provides reliable spark to ignite your burner. DIY-friendly fix restores consistent starts.
Replaced all ignitors. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.