White Westinghouse Parts

The drive blade has come off of the drum and the auger. When I try to dispense ice and the auger rotates, the drive blade does not rotate with it. Hence, the drive blade was not pushing ice into the drum (and into the ice crusher housing and dispense chute). Apparently, the hole of the drive blade was no longer "biting" the auger so that it will rotate with it. I did not know how to re-attach the drive blade back to the auger (short of welding it). So I ordered the Ice Container Assy. Took out... Read more

My Electrolux Frigidaire Gas Dryer stopped working and I got an error code E66 that the thermal limiter blew from over heating. The E66 code stops displaying after the initial code and you will then get a door open message. I replaced the thermal limiter and the thermostat just to be sure which part at the problem. The job is hard because you have to take apart the entire dryer and remove the drum. Would be a tough project to complete on your own. Read more

Watched the video a few times for door boot seal replacement. It was a lot of help! The spring is the hardest to replace and I did enlist the help of my wife. Everything went back on great. If you have to replace the front panel (with the buttons) be mindful that the buttons are spring loaded and will come out. I did not lose any and it went back together just fine. A little touch up paint on the washer and it all looks brand new and works great. And the parts came in quicker than... Read more

Looked up possible causes on line and found video about trouble shooting. It said to check starter cap and run relay on side of compressor. Removed both and found both were bad .ordered replacements on line from appliancePartspros.com. Installed new parts and is working properly. This repair job was on a 2012 Frigidaire refrig. You would think a refrig. Would last longer than 4 years. The original parts and the replacement parts were light weight and cheaply made. I'll probably be doing this... Read more

Had to pull double oven and range top out from wall which involved removing the upper kitchen cabinet. Took the sheet metal off the back and had the socket swapped out in a couple of minutes. My old oven works like a charm! Read more

• Door latch failure
• Door won't close

Replaced the door strike Read more

Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension. Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end... Read more

Ordered door bar and dairy tray cover from you, parts came next day. They slid/napped right in. To everyone: If you can change a roll of toilet paper, you can do this repair. Read more

• Leaking
• Not dispensing water

Turned off water behind the fridge. Unscrewed housing that covered water lines behind the filter base with a 1/4" socket. Pulled out the water hoses by pulling forward on the blue ring holding the hose while pulling the hose backward. Unscrewed the two screws below the filter base. Used the 1/4" socket to remove four additional 1/4" nuts holding the front housing until it partially dropped. I kept the housing propped on a jar. Unscrewed two additional screws holding the filter release rod in... Read more

Easy job, I screwed the parts to the dishwasher Read more

Ordered on Wed, received on Fri. Took less than 5 minutes to replace all 4. No tools needed. Read more

I encountered a high pitched squeal and loud rumbling. I figured the sounds were likely the rollers despite not matching other sounds on the repair videos for other dryers. The repair video for dryer rollers on AppliancePartsPros.com is of little use until Minute 2:56 because this Electrolux 517 model uses mostly Phillips head screw to fasten the front and top panels in place. You may find one latch at the top front center that holds the top and front panels in place. After unplugging the... Read more

I went online, ordered the part and installed it,,, took 15 minutes to install,,,saved huge $$$ easy peasy!! :-) Read more

Loosened the top half screws, pulled the old seal out, put new seal in, snugged top screws, repeated process for the bottom. Went well, no problems. Read more

I had purchased a model refrigerator that did not come with the deli/meat pan, and I was told by the manufacturer's customer service department that my purchased model was not designed with the item. I made comparisons with other models that had the deli/meat pan and found that the shelving alignments were the same so I decided to improvise and install the deli/meat pan. The manufacturer's customer service department did assist me with obtaining the appropriate part numbers and I placed the... Read more

I removed the old broken pin and replaced it with a new one, The shelf came as a complete assembly and was just put back in place. Read more