Whirlpool Dispenser Parts

I replaced the Ice Dispenser Lever. Since the replacement part is only available in white and my fridge is bone, I replaced also the Water Dispenser Lever, so it looks much better. I followed the instructions in the video, which were very useful and very well done. My problem was that the refrigerator is a KitchenAid built-in, while the instructions were for a Whirlpool, so the removal of the faceplate was quite different from what was shown in the video and more difficult. Also there were some... Read more

Ordered part, it fit perfectly! Read more

Ordered the new drawer. Read more

I removed the old one by lifting up and setting aside. I opened the box and set new part in place. There were no screws and other parts to assemble and the install was very easy! Read more

I bought the complete ice chute. It was easy to install and it works perfectly now. Many thanks. Read more

Replace the part and working good. Read more

Removed water catcher, then 4 screws in water/ice vault in door, then removed screws on door side (5) top (2) and bottom (2). Removed stainless door skin. Removed 4 hex head bolts in ice/water vault (containing pads) and 4 bolts on the module immediately above the vault. Pulled the vault and module above out part way to unplug one cable. Then laid on table to unplug pads. From back, each pad has a small indent preventing the pad from being pushed up and removed. Push the small indent with a... Read more

Removed drip pan from ice dispenser. Removed two screws hidden behind drip pan to loosen bezel at bottom. Carefully lifted bezel off top hook to expose controller board cabling. Disconnected three connectors to control board behind bezel to remove bezel completely. Removed two (possibly three) screws to access the back of the ice chute mechanism. Removed broken paddle that just snaps in, being careful to capture paddle spring. Put paddle spring on new paddle and maneuvered spring-end... Read more

I was moving my washer and dryer on to a platform when the washer slipped and the drawer came out and broke. I was going to surprise my wife with this new setup. She was out of town and was due back in 3 days. I didn't want her to see my mistake. I got on line and found AppliancePartsPros.com and I am glad I did. Their price was reasonable and fair. I order the parts I needed late on Wednesday and they were delivered early on Saturday. I watched their self help video on how to replace the parts... Read more

Super easy fix, remove two screws behind drop tray, unplug the wiring harness to dispenser, unplug and remove old pad, then snap new one into place. Reconnect harness. Took less than 5 minutes, works like new. Read more

Bought a new one, put it in, works like new Read more

Ordered the parts. Watched a great video on this web site. Installed. Fixed. Easy peesey. Read more

New dispenser. Worked perfect on Whirlpool. Read more

Repairman said I'd need to replace the entire chute inside at a cost of nearly $400! Ordered the chute myself for a little over $100. Took me about a half an hour to carefully disassemble the water/ice dispenser and replace with the new one. The job wasn't hard, I'm just not a very "handy" guy but I love a good challenge and am very careful not to pull and pry on things which may break. It was literally only 4 screws that had to be removed and some wiring harnesses holding everything together.... Read more