Whirlpool Motor

Ordered main control board and top blower. parts arrived as expected and well packaged. replaced main control board. Took two times to get ribbon cable inserted and aligned correctly. display functioned properly, but blower still not turning. replaced upper blower. everything working now. Read more

Installed a AP6007346 motor Read more

The auger would not turn the dispenser because the screw threads were stripped. I could not re-thread it so I had to replace the entire motor assembly. The video your company provided was extremely helpful not only for fixing the problem but to give me the confidence to do it myself. It was a very detailed video that included all the safety instructions. Read more

Installed new motor with a metal pulley from APP and VIOLA! Great service, support and inventory. HIGHLY RECOMMEND! Read more

Removed bottom cover plate and unscrewed motor housing Read more

This was a tricky one to figure out. The Maytag Centennial MVWC400XW4 would fill and wash, then stop before spin cycle or would not complete the spin cycle. We had to manually move the dial to rinse & spin, etc. to get it to finish a load. This technique worked but it definitely became a pain to do and at the time we didn't notice how much longer the machine took calibrating a wash load. I called Sears initially thinking I really didn't want to mess with this and they came out. They... Read more

I changed out the stator. Read more

Replaced evaporator fan motor. Read more

• Noisy

Refrigerator was not cooling, but was continuously runing & freezer compartment was extremely cold. Determined that fan assembly that takes freezer air & circulates to the refrigerator didn't seem to be working. Determined that the fan assembly motor was not rotating. Easily found replacement on AppliancePartsPro.com. Received the part quickly (Impressive delivery time!). Unplugged refrigerator, then easily removed to rear cover inside the freezer section by removing hex head screws.... Read more

My Kenmore washer had three problems and thanks to AppliancePartsPros.com videos I was able to repair all three. The washer coupler was defective so I replaced it. This topok about 30 minutes. The washer lid switch was defective. This took about an hour. Finally, the motor was defective. I was able to disconnect the motor from the transmission and test the motor by leaving the wiring connected and run a wash cycle. The motor was dead. I replaced it with a new motor and now the washer runs... Read more

Started out as a replacement of the coupling between the motor and the basket transmission ( 2 of the 3 legs on the transmission side broken.. )... Bought a new pump, since I would have it off... or so I thought.. Metal output shaft into pump + years of moisture = pump rusted on. Put it all back together - runs fine... for a while.. Then the old pump bearings burn out. Back apart.. Cut the old pump off the motor. Reinstall everything... Nothing, Just sits there and buzzes... Now... Read more

• Noisy

Used Google to troubleshoot the issue. Inside the freezer I took the back off. Noticed two things. The evaporator motor was not turning and the top half of the coils were frozen over. Obvious fan not spinning issue. I felt the motor and it was hot. Spun the fan it it started spinning. Put it all back together. Ran OK for 5-6 more days then same issue. I ordered the new motor and then and spun the fan again. It lasted for 2 days. Had to spin the fan to get it going 2 more times until... Read more