Whirlpool Switch

Fix a dryer that won't stop running when the cycle ends. This end of cycle switch signals the timer to stop. Simple DIY repair for most models.

Fix a washer that won't heat water or select the wrong temperature with this water temperature switch. Common DIY repair for temperature control issues.

This is a small micro switch used in the ice maker circuit to control the on/off function of ice production. It signals the appliance when to start or stop the ice making cycle based on ice level or timing. Replace this switch if your ice maker fails to produce ice, runs continuously without stopping, or does not cycle on and off properly.

This door switch detects when the appliance door is closed and signals the control so the unit can start or run. Replacing a faulty switch restores proper door-sensing and safe operation. What it does:

• Detects door open/closed status and sends the signal to the appliance control
• Prevents the unit from starting or running if the door is open
• Commonly linked to symptoms like the appliance not starting, not completing cycles, or lights/controls behaving incorrectly
• Works as the safety interlock for door-dependent functions

• One door switch

• Disconnect power before servicing to avoid shock or injury
• Match connector style and mounting alignment to the original switch before final installation
• Handle the switch and wiring gently to avoid damage to terminals or harnesses

Fix a dishwasher that won't start or respond to controls with this rocker switch replacement. Simple repair to restore button function and operation.

Fix a washer that won't advance through cycles or gets stuck mid-cycle with a new cycle switch. This repair typically takes 30-45 minutes.

Fix a washer that won't fill with water or overfills with this water level pressure switch. Controls proper fill levels during wash cycles.

Fix a washer that won't advance through cycles or stops mid-program. This cycle selector switch controls wash cycle progression and timing sequences.

This selector switch controls the operating mode of a trash compactor, allowing the user to choose between different compaction cycles. It is mounted on the control panel and connects to the unit's electrical circuit. Replace this switch if the compactor does not respond when you select a cycle, stays stuck in one mode, or fails to turn off properly.

Fix a dishwasher motor that hums but won't start or shuts down from overheating. This motor relay switch resolves intermittent pump operation issues.

Surface burner not heating or stuck on high? This range infinite switch controls cooktop element temperature. Common fix for heat control issues.

Range burner not heating or stuck on high? This infinite switch controls surface element temperature. Fits select KitchenAid ranges. Straightforward repair.

This cycle selector switch is the user control that selects and advances cooking/drying cycles, restoring reliable cycle selection and user control on compatible appliances. It provides a direct replacement for a worn or non-responsive selector. What it does:

• Rotates to select the appliance cycle and sends the chosen setting to the control system
• Restores proper cycle selection when the knob or control no longer changes settings
• Commonly used when cycles won't start, don't advance, or the control feels loose or intermittent
• Works as the mechanical/electrical interface between the user knob and the appliance control

• Disconnect power to the appliance before beginning any work
• Remove the control knob and panel trim to access the switch—keep track of screws and small parts
• Note or label wire locations before disconnecting; reconnect wires to the same terminals
• Test cycle selection and appliance operation after installation; if issues remain, check related controls and wiring

Fix a washer that won't advance cycles or starts agitating immediately with a new cycle switch. Located in the control panel for straightforward access.