Whirlpool Switch

Fix an unresponsive dryer button with this push-button switch replacement. Restores reliable front-panel operation when buttons don't register commands.

Fix a dryer that won't stop running when the cycle ends. This end of cycle switch signals the timer to stop. Simple DIY repair for most models.

Fix a washer that won't heat water or select the wrong temperature with this water temperature switch. Common DIY repair for temperature control issues.

Fix a dishwasher that won't fill or overfills with water. This float switch monitors water level and signals when to stop filling. DIY repair part.

Range oven light stays on or door won't latch? This door switch detects when the door is closed and signals the control. Simple DIY fix in minutes.

Fix a dishwasher that won't start or respond to controls with this rocker switch replacement. Simple repair to restore button function and operation.

Fix a microwave that won't start or heat when the timer counts down. This interlock switch is often the culprit. Moderately easy DIY repair.

Fix a washer that won't advance through cycles or gets stuck mid-cycle with a new cycle switch. This repair typically takes 30-45 minutes.

Fix a washer that won't fill with water or overfills with this water level pressure switch. Controls proper fill levels during wash cycles.

Fix a washer that won't advance through cycles or stops mid-program. This cycle selector switch controls wash cycle progression and timing sequences.

Fixes compactor light that won't turn on or off when door opens. This door switch controls light circuit operation. Direct fit replacement, easy install.

Fix a dishwasher motor that hums but won't start or shuts down from overheating. This motor relay switch resolves intermittent pump operation issues.

Surface burner not heating or stuck on high? This range infinite switch controls cooktop element temperature. Common fix for heat control issues.

Range burner not heating or stuck on high? This infinite switch controls surface element temperature. Fits select KitchenAid ranges. Straightforward repair.

Fix a dryer that won't start or stop when the door opens. This door switch replacement is a common repair that takes about 15-30 minutes to install.

This cycle selector switch is the user control that selects and advances cooking/drying cycles, restoring reliable cycle selection and user control on compatible appliances. It provides a direct replacement for a worn or non-responsive selector. What it does:

• Rotates to select the appliance cycle and sends the chosen setting to the control system
• Restores proper cycle selection when the knob or control no longer changes settings
• Commonly used when cycles won't start, don't advance, or the control feels loose or intermittent
• Works as the mechanical/electrical interface between the user knob and the appliance control

• Disconnect power to the appliance before beginning any work
• Remove the control knob and panel trim to access the switch—keep track of screws and small parts
• Note or label wire locations before disconnecting; reconnect wires to the same terminals
• Test cycle selection and appliance operation after installation; if issues remain, check related controls and wiring