Crosley Parts

Replaced exhaust thermal cutoff switch. Sears wanted to charge for a service visit + parts and labor. $17 part, $6 shipping and I received the part the following day. Repair complete in less than an hour at a fraction of the cost. Thanks appliance pros. Read more

We ordered a new handle and two screws. The part was very easy to find and was in stock. Shipped out in 2 days and delivered by fed -ex. My teenage son put the handle on in less than 5 minutes. very easy. So happy we can finally use the oven again. Read more

• Will not drain

I looked up the error code on the internet and determined that the drain pump had failed. I watched the Appliance Parts Pros repair video on how to replace this part, ordered a new pump and installed it myself in less than 30 minutes. This was an easy job that saved me the price of a service call, at least one hour of labor, and perhaps a markup on the part--probably around $200.00 total. I do this kind of work around the house a lot and win points with my wife. I still haven't received my... Read more

Replaced Snubber Ring installed spring kit. Watched installation video, found it very helpful to plan repair. The washer runs like new now. Read more

The manual had instructions for pulling things apart, the flaps over the drawer tops and the clear plastic inserts in the shelf. Flaps--Easiest to work with when the shelf is out and upside down. Slide flaps to the side a little to release the axle pin on the flaps from the receptacle hole on the shelf frame. Clear plastic plates are held in with a plastic pin on the side of the shelf frame. Carefully pull the side off the shelf there away from the pin slot until the insert pops out.... Read more

Rebalanced the load but noticed the drum was sitting lower and the springs were wore out and it went out of balance easy, so i got the suspension rod kit and installed it and it works much better. It took me 2 hours because i didnt have adequate room to move around. Hour job if you have room. Read more

The very easy diagnosis was motor seizure. Because the machine is about a decade old, I decided to renovate most of the guts. My DIY project included replacing the motor, blower, drum bearing, belt, and door hinge. The end result is a functional dryer with no left-over parts. Lack of parts and hardware challenged the effort. For example, the blower assembly did not have the slide capture for the motor. I had to use the old one which is showing its age. With the exception of the drum... Read more

• Noisy

No local refrigeration house had one. APP did! I got it in 2 days. Everything is A OK. Read more

Ordered and installed new ones. Read more

• Ice maker dispenses too much ice

Replaced the housing Read more

Thanking APP ahead of time for expedient 1 day express parts & videos! I kept a LOG on this repair fix starting 6/21/20: started with cleaning out behind the Frigidaire /coils, fan blade, floor, walls, toe-plate, compressor. #1 Replaced just the Run Capacitor [from my local appl store]. Somewhat better but not a fix. Fridge controls need much higher settings than Factory Settings - which is recommended. Did some homework on several sites /kept coming back to yours / saw what parts are probably... Read more

Ordered and installed new ones. Read more

Ordered part from appliancepartspros.com and got them within 2 days.that was great,refrigerator is like new again,am I am pleased with service and there swift delivery. If I need any thing else,there is only one place I will get them.from. Thanks! Read more

• Door sweating
• Door won't open or close

Replaced the lower hinge bearing and lower door cam on fridge side. Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

I ordered 1 assembly first and then another broke. so I ordered 2 more and replaced 2 more. The 4th was replaced last summer. I should have ordered 4 and replaced all when the 1st one failed. Read more