Dishwasher Cable Or Retainer

Replace your dishwasher's linkage spring if the original is stretched, broken, or missing. This spring connects and tensions the door linkage mechanism.

Spring cable for dishwasher door mechanism. Connects door to mounting bracket. Replace if cable is frayed, broken, or detached causing door misalignment.

The Dishwasher Door Cable Connector Assembly is an OEM replacement part for LG dishwasher. The cable connector assembly works with the door cable to properly guide and support the door as it moves through the full range of opening and closing motions. 

Causes of a bad door cable connector can include wear and tear over time resulting in cracks, loose connections, or broken or damaged connectors that no longer securely attach the cable. 

Symptoms of a bad door cable connector include:

• The door not properly aligning when closed 
• Difficulty opening or closing the door smoothly
• Noisy operation or rattling sounds from the door area
• The door not latching securely in place

This OEM LG part is also compatible with select Sears/Kenmore brand models.

Replacement electrical cable harness for dishwashers. Installs inside unit to restore power connections. Replace if original is damaged, frayed, or worn.

Secures and routes cables inside your dishwasher. Replace this holder if it's cracked, broken, or missing to properly support internal wiring connections.

This retainer lever secures and positions a moving component inside the appliance so doors, trays, or assemblies operate correctly. Replacing a worn or broken lever restores proper engagement and prevents loose or misaligned parts. What it does:

• Holds and guides a mating part or linkage in place to ensure consistent engagement
• Prevents assemblies from slipping or coming out of position during use
• Helps restore normal opening/closing or indexing behavior when the original lever is cracked or broken
• Works as a direct-fit replacement where the factory lever has failed

• One retainer lever

• Install with power disconnected and any moving assemblies supported or restrained
• Inspect adjacent clips, pins, or fasteners and replace if damaged—only the listed lever ships
• Use basic hand tools; avoid forcing components—ensure correct alignment before fastening

This retainer secures small appliance components in place to prevent shifting and ensure reliable operation. Fits into designated slots or mounting points to hold trim, panels, or assemblies securely. What it does:

• Holds panels or components in position to prevent rattling or misalignment
• Keeps trims, clips, or lightweight assemblies secured during operation
• Helps maintain proper spacing for moving parts and seals
• Can reduce vibration-related noise when installed correctly

• One retainer as pictured

• Disconnect power or water to the appliance before beginning any repair
• Inspect the mating surfaces and replace any damaged clips or broken mounts
• Typically installs with simple push-fit, snap, or screw engagement; have basic hand tools on hand

This wire tie secures and organizes wiring inside the appliance to help prevent chafing and loose connections. Its 7-7/8 inch length is suited for bundling harnesses and routing cables away from heat and moving parts. What it does:

• Fastens and groups wires or small hoses to keep them neatly routed
• Helps prevent wire chafing, abrasion, and contact with sharp edges
• Reduces the chance of intermittent connections from loose wiring
• Keeps wiring away from moving components to reduce noise and wear

• Disconnect power before servicing the appliance
• Position wiring as needed, insert tie and tighten; avoid over-tightening
• Trim excess tie length flush and secure cut end away from wires
• Replace any damaged wiring insulation and verify routing before restoring power