Frigidaire Damper & Related

This damper assembly controls airflow for the exhaust vent, opening with the blower and closing when off to block backdrafts. Replace a cracked, missing, or sticking damper to restore proper venting and reduce noise and drafts.

• Opens during fan operation to let cooking air exit through the duct; closes when off to prevent outside air from entering
• Helps maintain correct airflow to capture steam, smoke, and odors
• Common symptoms: poor venting, rattling/clacking noises, cold air drafts through the unit, visible broken or missing flap
• A stuck or binding damper can cause louder fan noise and weak airflow

• Disconnect power before servicing; remove the vent cover/adapter to access the damper
• Note airflow arrow and hinge orientation; install so the flap swings freely in the exhaust direction
• Reuse existing screws and seals; replace any damaged foil tape or gaskets to prevent leaks
• After installation, run the fan to ensure the damper opens/closes smoothly without rattling

This ceramic catalyst oven vent fits behind the oven broiler to help vent and break down cooking residues and odors at high temperatures, keeping oven air cleaner during cooking and self-clean cycles. It's a direct-replacement part when the original is cracked, clogged, or missing. What it does:

• Provides a heat-resistant vent surface that helps oxidize grease and odors that pass through the vent during use
• Helps maintain proper oven ventilation for consistent cooking and cleaner internal airflow
• Commonly replaced when the vent is cracked, glazed-over, excessively discolored, or emits persistent odors
• Works as part of the oven's venting system—does not affect electronic controls

• Disconnect power to the appliance before starting any work to avoid shock or injury
• Allow the oven to cool fully; this part is installed inside the oven cavity or broiler area and may require removing racks or access panels
• Handle with care—ceramic components can crack if dropped or flexed; wear gloves to protect hands and avoid fingerprints on ceramic surfaces

This chimney vent cover is the exterior metal shroud that finishes the range hood's vertical duct area and helps direct exhaust up into the ductwork. It restores the hood's finished appearance and ventilation pathway. What it does

• Covers and protects the hood's vertical duct section while maintaining a neat, finished look
• Guides exhaust upward into the house ductwork for proper ventilation
• Prevents exposure of internal components and duct seams
• Commonly replaced when dented, scratched, or missing

• One chimney vent cover

• Designed for bolt/screw attachment to the hood body or duct bracket; verify fastener locations before installing
• Turn power to the hood off at the breaker before any service that requires access behind panels
• Handle with care to avoid scratching the finished surface during installation
• If ducting or mounting hardware is damaged, replace those items separately; this part is the exterior cover only