Frigidaire Door, Door Glass & Parts

This replacement door glass forms the clear window in the door of select front-load units, restoring safe visibility and proper door fit. Replace a cracked, chipped, or shattered pane to prevent leaks and ensure the door seals and latches correctly. What it does

• Creates the viewing window in the door and mates to the door gasket/boot
• Helps maintain a proper seal to contain wash action
• Restores safe operation when the original glass is damaged
• Common symptoms: visible cracks or shattering, water leaking from the door area, door not closing flush, rattling glass

• 1 door glass pane

• Disconnect power and turn off water supply before service
• Wear cut-resistant gloves and eye protection; handle glass carefully
• Remove the door, set it on a padded surface, and transfer trim/gasket as designed
• Tighten fasteners evenly and check gasket alignment to prevent leaks

This outer glass door kit replaces a damaged or worn exterior oven/microwave door panel, restoring appearance and helping maintain proper heat containment. Designed as a direct-fit exterior glass assembly in black with pre-applied foil tape. What it does:

• Replaces cracked, chipped, scratched or cosmetically damaged outer door glass
• Restores the door's finished appearance and helps maintain the door seal integrity
• Works with the door assembly so heat and steam are properly managed during operation
• Helps eliminate drafts or light leakage caused by damaged outer glass

• Intended to be installed by a confident DIYer familiar with appliance disassembly
• Power off and unplug the appliance before starting; allow appliance to cool completely
• Take care handling glass; wear cut-resistant gloves and eye protection
• Follow OEM service instructions for door removal and reassembly to avoid damage

This shelf glass is a flat replacement shelf that restores usable storage space and a clean, stable surface inside the refrigerator. It fits into existing shelf rails to support food containers and help keep the interior organized. What it does

• Replaces a cracked, chipped or missing refrigerator shelf glass to restore safe, level storage
• Provides a smooth, easy-to-clean surface for storing dishes, produce and containers
• Helps contain spills and keeps items from falling through wire shelving gaps
• Matches OEM fit so it sits properly on the shelf supports and slides into existing tracks

• One shelf glass panel

• Handle with care; wear cut-resistant gloves to avoid injury from broken glass
• Remove any debris or broken pieces before installing the new glass
• Lift into place on existing shelf supports or rails; do not force or flex the glass
• If any shelf hardware is damaged, replace hardware before installing the glass

This outer door glass replaces the front glass panel on compatible Frigidaire laundry dryers, restoring the door's appearance and protecting the inner components. It provides a finished, clean look and a clear viewing surface for the dryer drum. What it does:

• Replaces cracked, chipped or scratched outer door glass to restore appearance
• Protects inner door components and insulation from debris and impact
• Maintains a clear viewing surface so you can check drum contents without opening the door
• Matches white trim/finish for a factory look

• 1 outer door glass (white) — exact item as shown

• Disconnect power to the dryer before starting any repair
• Handle glass carefully and wear cut-resistant gloves to avoid injury
• Installation may require removing the door trim and fasteners; keep track of screws/clips

This inner oven door glass assembly replaces damaged or cracked interior glass to restore a clear view into the oven cavity and help maintain proper heat containment. Designed to fit as the inner glazing panel in compatible Frigidaire oven doors. What it does:

• Replaces cracked, shattered, or fogged inner oven door glass
• Restores clear visibility to monitor cooking without opening the door
• Helps maintain oven heat containment and consistent cooking performance
• Reduces risk of injury from broken glass when the door is damaged

• One inner oven door glass assembly

• Installation may require removing the oven door and separating door panels; follow the manufacturer's service instructions
• Handle glass carefully and wear cut-resistant gloves and eye protection
• Ensure all fasteners and any gasket or trim pieces are reinstalled per OEM guidance

This replacement frame restores the appliance's outer trim and helps hold the control/door area together for a clean, finished appearance. It's a direct-fit exterior trim piece that replaces damaged or worn frames. What it does:

• Replaces a cracked, chipped, warped or bent trim/frame that affects appearance
• Secures and aligns the surrounding control or door components to reduce gaps and rattles
• Covers internal edges to help keep out dust, moisture and debris
• Restores the original look after impact or wear

• Disconnect power to the appliance before starting any repair
• Remove required trim, screws or clips to access and replace the frame; keep fasteners for reuse unless damaged
• Handle edges carefully—trim pieces can be sharp; use proper hand protection

This replacement door transition ring restores the trim and alignment where the appliance door meets the cabinet, helping the door close smoothly and improving the unit's appearance and seal. What it does

• Covers and protects the gap between the door and cabinet, preventing rubbing and wear on edges.
• Guides the door for consistent closing and helps reduce drafts or uneven sealing.
• Stops rattling or banging caused by worn or damaged trim pieces.
• Restores finished look to the door area when the original ring is cracked, broken, or missing.

• One door transition ring.

• Disconnect power (or unplug unit) before starting any work to avoid electrical or injury hazards.
• Most installs are snap-in or require removing the door or outer panel—use basic hand tools and avoid forcing parts.
• Handle the trim carefully to avoid cracking; replace any damaged fasteners or clips rather than reusing broken pieces.

This genuine OEM part is a washer lid. The washer lid is the main piece that covers the washer. Over time, a washer lid can become damaged to the point where it no longer closes securely. If the washer lid is no longer closing all the way or is severely cracked or damaged, it will need to be replaced.To replace this part, start by making sure the washer is unplugged. After it has been powered off, proceed to take a putty knife to lift to release the two retaining clips that secure the washer's main top. Once released, proceed to remove the lid lock assembly wire connector. Fully remove the main top and set it upside down. Release the tension on the lid springs and detach the springs from the main top and hinge bars. Using a Phillips head screwdriver, remove the screws that secure the hinge bars to the lid. Push the hinge bars through the bearings then twist the bars to remove them. This will separate the lid from the main top. Take the new lid and align it with the main top. Insert the hinge bar between the main top and bearing while threading the screws to secure the new top. Reinstall the top panel and connect the wire harness. This replacement part is sourced directly from the manufacturer and is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, and Westinghouse brand washers.

This inner oven door glass replaces a cracked or damaged oven door window to restore visibility and help the door seal properly. It fits behind the exterior door panel and provides a clear view of the oven cavity while resisting heat. What it does:

• Replaces cracked, chipped, or shattered inner oven door glass
• Restores clear visibility into the oven for safe cooking monitoring
• Helps maintain proper oven door seal and reduces heat loss
• Prevents loose glass fragments from entering the oven cavity
• Compatible with oven door assemblies that use a single inner glass panel

• Disconnect power to the appliance and ensure the oven is completely cool before beginning.
• Wear cut-resistant gloves and eye protection when handling glass to avoid injury.
• Removal usually requires opening the oven door and removing fasteners or clips; keep track of all screws and brackets.

This is the glass panel used in the oven door window. Replace it to restore a clear view into the oven and maintain the door's proper heat barrier if the original pane is cracked, shattered, or damaged.

• Forms the viewing window and thermal barrier in the oven door
• Helps the oven retain heat for consistent cooking
• Direct replacement for a cracked, shattered, or missing pane
• Typical symptoms: visible cracks, shattered glass, rattling fragments, or reduced visibility

• Disconnect power or gas and allow the oven to cool completely before service
• Wear cut-resistant gloves and eye protection; handle broken glass with care
• Support the door; remove the door and any trim as outlined in your model's service information
• Transfer any reusable brackets/trim from the original glass and avoid overtightening fasteners

This front control panel is the exterior trim piece that covers and protects the appliance's user controls and display, restoring the unit's appearance and keeping the control area sealed from dirt and moisture. What it does:

• Covers and protects push buttons, touch controls, and the display area from damage and debris
• Provides the visible interface and trim around the control electronics
• Restores a clean, finished appearance when the original panel is cracked, scratched, or discolored
• Helps maintain a proper seal around controls to reduce dirt and moisture intrusion

• Disconnect power before starting work to avoid electrical shock
• Remove the old panel by following the appliance's service guide to avoid damaging clips or adjacent parts
• Handle the replacement panel carefully to avoid scratching the finish during installation

Replace a cracked or cloudy door window with this outer lens. It forms the transparent exterior panel of the door, protecting the inner window and restoring a clean look and clear view into the drum during cycles.

• Forms the exterior, see-through panel of the door window
• Shields the inner window and helps the door close evenly against its trim
• Replace if the outer window is cracked, chipped, warped, loose, or discolored/cloudy
• Damage may cause poor visibility or sharp edges around the door opening

• Disconnect power before servicing the appliance
• Remove the door and place it on a padded surface
• Separate inner/outer door panels, note screw locations, and lift out the old lens
• Clean mating surfaces; set the new lens in place and reassemble without over-tightening screws