Frigidaire Refrigerator Parts

• Fridge too warm

Fan motor went bad. Fixed the fridge for less than it would have cost me just to have someone come out and look at it. Read more

• Ice maker dispenses too little ice

When I first searched the AppliancePartsPros.com site for my specific model, the ice maker that appeared in the parts list was not for my refrigerator. So, I bought one from one of your competitors. It arrived and worked but produced ice even more slowly than my original unit, albeit at 0F. So, I went back to AppliancePartsPros.com parts list and browsed completely through it only to find another ice maker that did match mine. It was almost twice the cost, but after installing it, worked... Read more

Front-wheel attaches to the shelf above. Where it screws in is kind of flimsy, no way to repair, had to replace the entire shelf, including the glass. Appliances Parts Pros had the best price, and it arrived quickly. You have to swap the metal brackets from the old to the new shelf (2 brackets x 5 screws), and reuse the old wheels as well. One thing to note, the holes for the screws and for the wheels are not threaded. The screws cut the threads. Use caution when putting in the screws and... Read more

I believe we had two problems. Our gasket was ripped in several places and our drain pan line was clogged. Therefore the water was frozen and backing up into the freezer. Replacing the gasket is an easy job and could possibly be done quickly enough that you don’t have to remove your freezer food items if you don’t discover additional problems during the process. The most time-consuming part is the approximately 40 screws that hold the freezer door shelf panel and gasket to the door itself. ... Read more

I ordered the replacement part. Your website was the only one I searched which exactly identified the correct part for me to order. The exploded diagram with numbered parts was very helpful. Read more

If you can't pull out the displacement pins on the crisper cover support clips that allow the wall to carry the weight of the cover, slides and drawer, you may need to push those pins in (they fall down the wall) to remove the clip. During the replacement of both front clips, I had one I could remove and one I had attempted to drill a tiny hole in to be able to pull the pin. Ultimately it did not work and needed to be simply pushed in. Do not worry, there is nothing below which the plastic... Read more

Replaced door switch - it took less than 5 minutes - works perfectly Read more

I ordered new parts from your company for my refrigerator. These were easy parts to replace and did not require tools. I was most grateful in being able to order those parts by telephone from your company. This process was surprisingly easy and did not require a long wait to speak to a representative. The persons I spoke with were polite, efficent and very competent. The parts got to me very quickly in well packed boxes. I though this process would be an ordeal and it was the opposite. This was... Read more

Unfortunately, this part isn't sold separately, but the plastic that is attached to the metal spring that allows the actuator to disengage broke and I had to physically pull the "paddle" part back up for the water to stop coming out. Easy removal with a square bit screwdriver. First, take off the trim piece underneath the LCD display (screws are underneath), then take out the screws for the LCD display and pull down and out, then unplug the wires. Then take the screws out of the actual part... Read more

They just slide in place. One shelf was broken and I had to reorder. Received the replacement within 48 hours. Read more

Put racks to together and put into fridge Read more

Before we replaced the board, my wife tried to replace just the element. We had one we had ordered several years ago when this same thing happened. When that didn't work we replaced the board and could see where the old board was damaged so we figured this was the solution. It would have been except the bottom element my wife used to replace the old element (which was fine but had been thrown out figuring the new one was new so why keep the old one) was 1" shorter in the back than the old... Read more

Ordered part from your website. Fit perfectly Read more

Ordered parts from appliance part pros Read more

Replace them. Out of two shelf guards 1 was broken Read more

I ordered the plastic frames from Applianceparts.com. When they arrived I placed the unbroken glass within the frames. Very simple! Read more