General Electric Dishwasher Parts

Replaced heating element. Read more

I ordered the part plus I replaced all of the other rubber/plastic parts just in case. My dishwasher is ten years old and still works great. Read more

• Leaking

I replaced the pump drain assembly. The flapper valve was included in the assembly, so I did not need to order that. On previous repairs, the old drain hose was tricky to reinstall, so I replaced it and the hose clamp.The silverware basket had holes in the bottom and required replacement. I had some broken tine clips. Read more

Just popped it in, easy as pie. Read more

The replacement of the arm took a total of 3 minutes, all I needed was a nut driver for the easy job, taking the old arm out and putting the new one in, exact replacement , I appreciate you getting the part out as fast as you did. It took an extra day because of the ice storm we had . That was ok. Thanks you . Read more

First, I took the whole thing apart and cleaned every spot...the main culprit seemed to be the float. It was pretty gunked up and seemed to be not working...after a good cleaning it was fine...but once I pulled the unit out and checked underneath I noticed the heating element was loose, leaking, and had burnt off the blade connecting ire. So I promptly bought this replacement, installed it in about 5 minutes, did a clean cycle, and shes back to normal...I love AppliancePartsPros.com, and use... Read more

I replaced the main control board kit and everthing worked like it should work. Read more

Put new hose on. It was the kind that pushed in and had a flange on it with two screws. Read more

• Will not fill with water

Took the washer out, turned it over and found the solenoid that worked the drain valve to be melted, and the shaft that the solenoid activates was heavily corroded. I found the right parts on your website after reading the notes left by other customers, then watched the video. The repairs were fairly simple and successful. This was a GE profile dishwasher. Read more

Replaced the pump and drain hose. The pump was easy. The replacement parts were identical to the bad parts. The drain hose was full of gook and smelled awful so I decided to replace that as well. The tag on the new hose alerted me to the procedure for installing a drain hose. If your dishwasher is not vented you need to create a high hose loop so that excess particles from the garbage disposal or dishwasher don't stay in the hose. The person that installed the dishwasher failed to do this which... Read more

I did an internet search - found your site explaining how to fix. I purchased the upper, middle, and lower spray arms - It took about 15 minutes total. Very very easy. No more dirty dishes! Read more

Parts work great fit perfectly all is fixed. Read more

Turn off power to machine, Take off door panel - 12 screws. hold up door panel a bit and make sure to remove the ribbon from the touch pad to the control module (use some pliers to rock it out of the board). Since I was changing the Module, I just removed the 1 screw that held it in place and it gave me some more room to get my hands in there and remove all the wiring freeing up the board to remove the touch pad ribbon last (I didn't want to tear it because I was not replacing it and after 9... Read more

Repair parts arrived super fast. Installed the new parts according to the supplied instructions. All went well. It took over 2 hours because the unit had to be removed after the water and power were disconnected and then the initial problem diagnosed (motor brushes worn beyond service limits). The removal of the spray bar tower assembly was a challenge until it was discovered that the tower unscrews in a CW direction from the bar that then allowed access to the attachment screw that holds that... Read more

• Won't start

The new knob I ordered fixed the problem. Read more