General Electric Refrigerator Bumper, Bushing, Grommet Parts

This replacement freezer bottom hinge bushing helps the freezer door pivot smoothly and maintain proper alignment, reducing rubbing and uneven wear for more reliable closing. What it does:

• Provides a smooth pivot surface for the freezer bottom hinge
• Restores proper door alignment to help ensure a tight seal
• Reduces hinge noise, sticking, and rubbing during door movement
• Helps prevent premature wear of the hinge and door components

• One freezer bottom hinge bushing

• Disconnect power to the appliance and empty or support the door before starting
• Support the door while removing hinge fasteners to prevent falling or injury
• Inspect the hinge and shaft for wear; replace the hinge assembly if damaged
• Do not overtighten fasteners; test door operation after installation

A single PCB stand-off used to support and insulate a control circuit board from the appliance chassis, helping prevent shorts and vibration damage. Fits as a direct replacement where the board needs secure, spaced mounting. What it does:

• Keeps the printed circuit board elevated and electrically isolated from the metal chassis
• Reduces risk of short circuits from contact or conductive debris
• Helps limit board movement and vibration-related connection issues
• Used whenever a loose, damaged, or missing spacer causes board contact or instability

• Power off and disconnect the appliance before accessing the control board
• Replace only the same standoff location/size to maintain proper clearance
• Use appropriate non-conductive fasteners; do not overtighten to avoid cracking the spacer

This rubber door switch grommet cushions and secures the door/light switch assembly, helping ensure a stable switch fit and quiet operation. It replaces a worn or missing grommet to restore proper switch positioning and reduce rattling. What it does

• Holds the door/light switch in the cabinet opening for proper alignment and contact
• Cushions the switch to prevent vibration noise and wear
• Helps keep the switch sealed against dust and debris
• Can stop intermittent light or switch contact caused by a loose or deteriorated grommet

• One rubber door switch grommet as pictured

• Disconnect power to the appliance before starting any repair
• Remove the door panel or switch bezel per your model's instructions to access the switch
• Push the grommet into the switch opening, then seat the switch through the grommet until it snaps into place