General Electric Refrigerator Bumper, Bushing, Grommet Parts

This top hinge bushing helps the refrigerator door pivot smoothly and reduces metal-on-metal wear. Replacing a worn bushing restores quieter operation and helps the door align and close properly. What it does:

• Provides a low-friction mounting surface for the top hinge pin
• Reduces hinge noise, squeaks, and grinding when opening or closing the door
• Helps maintain proper door alignment and sealing by preventing excess play
• Prevents accelerated wear of the hinge pin and surrounding trim

• Always disconnect power to the appliance before starting any repair
• Support the door securely before removing the hinge to avoid injury or damage
• Inspect hinge pin and surrounding components; replace if heavily worn
• Hand-tighten fasteners, then torque to manufacturer specifications; avoid over-tightening plastic components

This Grommet Link Assembly cushions and secures moving parts, helping reduce vibration and wear for a quieter, more reliable appliance operation. Use it to restore proper fit between linked components. What it does:

• Absorbs shock and reduces vibration where two components connect
• Keeps linked parts aligned to prevent rubbing or premature wear
• Helps stop loose or rattling noises caused by worn grommets
• Prevents metal-on-metal contact that can cause damage over time

• Install only after disconnecting power to the appliance to avoid injury
• Inspect surrounding components and mounting hardware; replace any damaged fasteners
• Seat the grommet fully into its mating holes to ensure proper alignment and function

This euro standoff kit provides the mounting hardware used to secure trim panels and components on compatible appliances, restoring proper panel alignment and preventing rattles or loose trim. It's a direct-fit replacement for the listed part number. What it does:

• Replaces worn or damaged mounting standoffs that hold panels or trim in place
• Restores secure panel attachment to reduce vibration, rattling, or misalignment
• Helps maintain proper spacing between panels and cabinet for correct fit and finish
• Designed to match the original part's fit and function for reliable repair

• Disconnect power to the appliance before servicing to avoid shock or injury
• Remove affected trim/panel carefully to access standoffs; retain screws and hardware
• Install standoffs in the original locations and tighten screws until snug — do not overtighten
• If alignment issues persist after replacement, check adjacent clips, fasteners, and mounting surfaces