General Electric Refrigerator Bumper, Bushing, Grommet Parts

This rubber damping bumper cushions and reduces vibration where two appliance components meet, helping doors and panels close more softly and preventing metal-on-metal noise and wear. It's a simple replacement that restores quieter operation. What it does:

• Absorbs shock and vibration between mating parts to reduce noise
• Helps door or panel close smoothly and prevents slamming
• Prevents direct metal-on-metal contact to reduce wear and rattles
• Small, flexible pad designed to sit in a mounting recess or on a bracket

• One rubber damping bumper

• Small part; verify mounting location and orientation before removing the old bumper
• Use basic hand tools as needed; replace only after disconnecting power if working near electrical components
• Inspect surrounding brackets and fasteners for damage and clean mounting area before installing
• If adhesive is present, allow it to cure per manufacturer instructions before normal use

This molded rubber condenser grommet cushions and positions the condenser assembly to reduce vibration and wear. It restores proper mounting alignment so the condenser sits securely and operates quietly. What it does:

• Cushions condenser against the cabinet frame to dampen vibration and rattling
• Helps hold the condenser in proper position for correct airflow and clearance
• Prevents metal-to-metal contact that can cause noise or part wear
• Commonly used when the condenser rattles, vibrates, or sits loose after impact or age

• One condenser grommet

• Disconnect power to the appliance before servicing to avoid electrical shock
• Access the condenser from the back or lower rear, remove any service panels as needed
• Remove the old grommet and press the new grommet into place on the condenser mounting post or bracket

This rubber grommet seals the suction/water pipe where it passes through the appliance cabinet to reduce leaks and dampen vibration. It restores a tight, durable seal to help prevent water intrusion and rattling. What it does:

• Cushions and seals the suction/water pipe where it passes through sheet metal or plastic.
• Reduces vibration and pipe movement that can cause noise or wear.
• Helps prevent water leaks or moisture entry at the cabinet penetration.
• Maintains a proper fit for tubing routing and component alignment.

• One rubber suction pipe grommet.

• Disconnect power and shut off water supply before servicing.
• Remove access panels as needed to reach the pipe penetration; press grommet into opening and route pipe through center.
• Replace any brittle, torn, or deformed grommets; do not force a damaged grommet into place.