General Electric Refrigerator Shaft Or Pin

Lower drawer pinion gear for refrigerators. Installs on the right side drawer mechanism. Replace if gear teeth are stripped, worn, or broken.

Lower drawer pinion gear for refrigerators. Installs on the left side drawer mechanism. Replace if cracked, stripped, or missing to restore smooth operation.

Wire actuator rod for refrigerator dispenser mechanism. Connects dispenser controls to activate ice or water. Replace if bent, broken, or missing.

Structural reinforcement bar for refrigerator interior framework. Replace if cracked, bent, or broken to restore cabinet support and stability.

Dowel pin for refrigerator structural assembly. Replaces broken, missing, or worn pins. Essential for proper alignment and secure installation.

Secures the compressor to the refrigerator base. Replace if stud is stripped, broken, or missing to properly mount and stabilize the compressor unit.

This replacement key pivot is the small pivoting pin that supports the refrigerator/freezer door key or latch mechanism, restoring secure pivoting and smooth operation at the key location. A direct-fit OE-design replacement. What it does

• Provides the pivot point for the door/key mechanism so the key or latch rotates smoothly
• Restores proper alignment when the original pivot is worn, bent, or broken
• Helps prevent a loose or wobbly key or a latch that fails to engage
• Works as a simple, serviceable part of the door/lock assembly

• One key pivot

• Disconnect power to the appliance before beginning any repair
• Remove door trim or access panel as needed; keep small parts organized
• Replace the pivot and check movement; avoid forcing parts that do not align

Switch actuator pin for refrigerators. Installs in door or control assembly to trigger switches. Replace if broken, bent, or missing to restore proper fit.

A small spring-style cotter clip that secures shafts and pins to keep moving parts in place. Restores a secure fit to linkage, rods, and pivot points so components stay aligned and don't slip free during operation. What it does:

• Holds shafts, pins and rods in position to prevent components from sliding off
• Provides a spring tension lock around a grooved pin or hole for reliable retention
• Commonly used on linkage, pivots and fastener pins where a compact retaining clip is needed
• Helps stop rattling, loose connections or parts that drop out of place

• Disconnect power before servicing any electrical appliance and work with the appliance in a stable position
• Use needle-nose pliers to spread and install the clip over the pin groove; ensure it seats fully
• Inspect mating pin/hole for wear or damage and replace if deformed
• Replace with an identical clip size and style to maintain secure retention