General Electric Refrigerator Screws, Nuts, Washers

Includes 12 washers.

Size: 10-16 ab.

Package of 12

This is a self-tapping Phillips head screw used to secure various components inside the refrigerator. It measures 8-18 thread size and 1/2 inch in length. Replace if the original screw is stripped, missing, or damaged during a repair, which can cause panels or parts to come loose.

This plug-in SCR is a solid-state replacement that controls electrical power to appliance circuits, restoring reliable on/off control and helping eliminate intermittent operation. It's a direct-fit replacement when the original SCR fails. What it does

• Regulates current flow in the control circuit to switch power to motors or heating loads.
• Stops erratic cycling or loss of power caused by a failed control semiconductor.
• Helps restore consistent operation when an appliance has intermittent start, no heat, or no motor run.
• Provides a rugged, compact replacement with a 5/16" connection style.

• One plug-in SCR

• Disconnect power to the appliance before accessing or replacing the SCR.
• Remove the appliance's control or access panel to reach the control board; note wire locations before unplugging.
• Plug the new SCR into the original connector or replace per the service manual.
• Verify correct operation after installation and reassemble all panels before restoring power.

Self-tapping screw fastens appliance panels, brackets, and trim by cutting its own thread. Replace missing, stripped, or broken screws during repairs.

Phillips pan head screw for refrigerators. Secures trim panels, brackets, and internal components. Replace stripped, missing, or corroded fasteners.

Stainless steel fastener secures refrigerator door handle to mounting point. Replace if worn, missing, or stripped to fix loose or wobbly handle.

Secures mobility components and wheel brackets on side-by-side refrigerators. Replace if screw is missing, stripped, or worn to restore stable mounting.

Shoulder-style bolt that secures moving parts in refrigerator mechanisms. Replace if worn, damaged, or missing to restore proper alignment and smooth operation.

Phillips flat-head screw secures panels, brackets, and internal components in refrigerators. Replace missing, stripped, or corroded fasteners.

This pack contains twelve replacement screws used to fasten appliance panels, trim, and components. They restore secure mounting and help stop rattling, loose panels, and gaps for a safer, quieter appliance. What it does:

• Secures exterior and interior panels, brackets, and trim pieces
• Restores proper fit where missing or stripped screws cause movement or noise
• Helps maintain appliance alignment and prevents parts from vibrating loose
• Used for general-purpose repairs on compatible GE appliances

• Disconnect power or unplug the appliance before performing any internal repairs
• Use the correct screwdriver bit and avoid overtightening to prevent stripping threads
• Keep remaining screws in a labeled container for future service
• If a screw does not seat easily, stop and verify correct fit to avoid damage

This screw is a factory replacement fastener used to secure appliance panels and components. It restores lost or loose hardware so parts sit correctly and operate without rattling or movement. What it does

• Secures panels, brackets, and small components to the appliance frame
• Restores proper alignment and helps eliminate rattling or vibration
• Replaces missing or stripped fasteners that prevent parts from staying fixed
• Matches OEM fit for reliable fastening where the original screw was used

• One replacement screw

• Use the correct-size screwdriver or driver bit to avoid stripping the head
• Power off and unplug the appliance before accessing internal components
• Tighten snugly but avoid overtightening to prevent thread damage
• Keep removed hardware organized so you can install replacements in the original locations

Package of 12