General Electric Refrigerator Valve

This water valve kit controls the flow of water from your home supply to the refrigerator's icemaker and/or dispenser. Replacing a sticking or leaking valve helps restore proper fills and dispensing performance. What it does:

• Opens and closes to supply water during icemaker cycles or when the dispenser is activated
• Can improve slow or intermittent fills
• Addresses leaks originating at the valve body or its connections
• Symptom-based clue: audible buzzing from the valve with little/no water flow

• One water valve kit

• Disconnect power and shut off the household water supply before servicing
• Place a towel to catch residual water and relieve line pressure
• Note wire and tube locations; cut plastic tubing square and fully seat into push-in fittings
• Restore water and power, then check all connections for leaks and run a test fill

This water inlet valve assembly controls water flow to the dispenser and ice maker, restoring proper fill and dispensing when the valve is the source of the problem. Replaces a failed or leaking inlet valve to resume normal water delivery. What it does

• Opens and closes to let water into the ice maker and dispenser when signaled
• Stops water flow when closed to prevent continuous filling or flooding
• Commonly linked to no water dispensing, slow/weak fill, or intermittent filling of ice maker
• Helps stop leaks or drips when the internal valve seat is failing

• One water inlet valve assembly

• Disconnect power and shut off water before replacing to avoid electrical shock and flooding
• Verify water supply line is depressurized and dry before disconnecting fittings
• Tighten plumbing connections to the manufacturer torque recommendations; check for leaks after installation

This water valve assembly controls water flow into the appliance, providing reliable fill operation for the dispenser/ice system. It replaces a worn or failed valve to restore proper water delivery and help prevent unwanted leaks. What it does:

• Opens and closes water flow to the appliance when signaled by the control
• Stops water flow to prevent overfilling or flooding when functioning correctly
• Commonly used when the appliance won't fill, makes no water available, or continuously runs water
• Helps ensure proper water supply to ice makers and dispensers

• Disconnect power and shut off the water supply before starting work
• Allow access to the valve and relieve any line pressure before disconnecting fittings
• Inspect and replace any damaged hose or seal while installing the new valve
• Test for proper operation and leaks after installation

This water valve assembly controls cold-water flow to a refrigerator's dispenser and ice maker, restoring proper water supply for filling and ice production. It replaces a failing inlet valve to stop no-water or intermittent-fill issues. What it does:

• Directs household water into the refrigerator dispenser and ice maker when solenoids are energized
• Commonly used to fix no-water from dispenser or ice maker and slow or inconsistent filling
• Stops leaks caused by stuck or damaged valve components when replaced
• Works with standard 1/4" water line fittings used on many refrigerators

• One water valve assembly

• Turn off the refrigerator and shut off the household water supply before beginning
• Relieve line pressure and disconnect the water line; beware of residual water in lines
• Inspect supply tubing and fittings; replace damaged tubing or seals as needed
• After installation, restore water, check all connections for leaks, and run a test dispense/cycle