Kenmore / Sears Support Parts

This left-side tapping plate/gusset is a metal mounting bracket that reinforces appliance panels and hinge areas, restoring secure attachment and alignment for doors or panels. It helps reduce wobble and maintains proper fit where the original bracket is damaged or worn. What it does:

• Reinforces and secures hinge or panel attachment points to restore alignment
• Provides a threaded or tapped surface for fasteners where sheet metal cannot accept screws
• Stops movement or sagging that can cause gaps, noise, or poor door sealing
• Helps prevent further damage to the cabinet or door mounting area

• Always disconnect power (and water, if applicable) before beginning repairs
• Inspect mounting holes and surrounding metal; remove any damaged fasteners or debris before installing
• Use the correct replacement screws and hand-tighten, then torque to manufacturer specs if available; do not over-tighten
• If the cabinet or hinge area is severely corroded or stripped, additional repair or reinforcement may be required

Lower hinge tapping plate for refrigerators. Secures the bottom door hinge to the cabinet frame. Replace if cracked, stripped, or damaged.

Mounting base that secures the compressor to your refrigerator frame. Replace if cracked, broken, or damaged to properly support the compressor unit.

Refrigerator support base plate that mounts components securely. Replace if cracked, broken, or missing to restore proper structural support.

This plate is a flat mounting plate used to secure internal components and assemblies on compatible Frigidaire appliances. It provides a stable attachment point to keep parts aligned and reduce vibration for reliable operation. What it does:

• Serves as a mounting/support plate that fastens appliance components in place
• Helps keep moving parts aligned to prevent rattling or misalignment
• Restores secure attachment when a worn or damaged plate causes loose panels or parts
• Commonly used where a flat bracket or support is required inside the appliance

• Disconnect power (unplug appliance or shut off circuit breaker) before starting any repair
• Remove surrounding panels as needed to access the mounting location; keep hardware for reuse unless damaged
• Reuse original screws if in good condition; replace stripped or damaged fasteners

Support plate that secures the burner tube assembly in your range. Replace if cracked, warped, or corroded to properly mount and stabilize burner components.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.