Kenmore / Sears Parts

Range burner won't heat or stays on high? This infinite switch controls surface element temperature settings. Common fix for heat regulation issues.

Dryer not heating or overheating? This resistor regulates temperature control in your dryer's heating system. Simple DIY replacement part.

Fix a dishwasher that won't advance through cycles or stops mid-wash with this cycle extension switch. Moderate DIY repair for most models.

Fix a refrigerator light that won't turn on or off with this door-activated light switch. Simple 15-minute repair for most home DIYers.

This is a black rocker switch used to control a function on compatible ranges/cooktops. Replacing a worn or inoperative switch restores positive on/off control and reliable operation of the connected feature.

• Controls an appliance function (such as a light or igniter circuit) with a single on/off action
• Common failure signs: switch won't stay on, no response when toggled, intermittent operation, or physical damage/discoloration
• Direct-fit replacement designed for the original switch location
• Helps restore safe, predictable control to the appliance

• Disconnect power and, if applicable, shut off gas before servicing
• Access is typically from the control panel; retain orientation of wires and note terminal positions
• Transfer wires one at a time to the new switch to avoid miswiring
• Inspect connectors for heat damage; replace damaged terminals before reassembly

Refrigerator not cooling properly or running constantly? This door reed switch detects door position to control interior lights and cooling cycles.

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

If your range burner won't heat, stays on high, or won't turn off, the infinite switch may be faulty. This part controls surface element temperature.

This is a black rocker switch used on a range or oven control panel. It functions as an on/off toggle for a specific feature such as a light or fan. Replace this switch if it no longer clicks into position, feels loose, or fails to activate the associated function when pressed.

Fix range display issues, unresponsive controls, or error codes with this control board assembly. Common repair for ranges that won't start or heat properly.

Warming drawer not heating or won't turn on? This control switch regulates temperature settings. Moderate DIY repair requiring basic tools and care.