Maytag Bumper, Bushing, Grommet Parts

The refrigerator top hinge shim is a thin spacer that fits between the top hinge and the refrigerator cabinet to fine-tune the alignment and level of the door. It helps ensure the door hangs evenly, seals properly, and closes without gaps. Replace or add this shim if the refrigerator door sags, doesn't close flush, or the door gasket isn't sealing evenly around the top of the door.

Hinge shim for ice makers. Installs between hinge components to maintain proper door alignment. Replace if worn, cracked, or missing for smooth operation.

Rubber bumper. Color: Grey.

Spacer that mounts between the washer cabinet and top panel. Replace if cracked, broken, or missing to maintain proper spacing and alignment.

Rubber cushion that mounts between the drain pump and washer frame to reduce vibration and noise. Replace if worn, cracked, or missing to restore support.

The disposer sleeve is a protective collar that connects the garbage disposer to the sink drain and prevents debris from escaping. Replace it when you notice leaks around the connection point or food particles escaping into the drain area.

Rubber bumper stop cushions moving range parts to reduce vibration and noise. Replace if worn, cracked, or missing to restore proper spacing.

Rubber bumper cushions washer components to reduce noise and vibration. Replace if cracked, worn, or missing to protect cabinet surfaces and keep panels aligned.

This snap-in bushing provides a low-profile bearing surface to support rotating shafts and reduce wear and noise in appliance assemblies. It restores smooth operation where the original bushing is worn or damaged. What it does:

• Provides a replaceable bearing/sleeve for rotating shafts and posts
• Reduces friction and wear on housing and moving parts
• Helps eliminate rubbing, grinding, or rattling noises during operation
• Maintains correct shaft alignment for smooth rotation

• One snap-in bushing

• Disconnect power before servicing and follow all safety instructions
• Access may require removing panels or covers; inspect surrounding parts for wear
• Press or snap the bushing squarely into the housing until fully seated; avoid deforming it
• Replace any damaged retainers or seals and test operation after reassembly

Spacer bushing for freezers. Maintains proper clearance between components. Replace if cracked, broken, or missing to prevent rattling or misalignment.

Hinge bushing for bottom-mount and standard refrigerators. Replaces worn, cracked, or missing bushings that support door hinge movement.

Black center hinge shim for refrigerator doors. Replaces worn, cracked, or missing shims that support proper door alignment and spacing at the hinge.

Refrigerator shim used to level and stabilize components. Replace if worn, missing, or damaged to ensure proper alignment and prevent vibration.

Snap-in spacer for range installation. Provides proper spacing and alignment between components. Replace if cracked, broken, or missing to restore fit.

Rubber grommet for cooktop installation. Seals and cushions components to prevent rattling and vibration. Replace if worn, cracked, or missing.

Plastic spacer that supports the lid hinge assembly on top-load washers. Replace if cracked, worn, or missing to restore proper lid operation.