Maytag Refrigerator Drawer, Shelf, Pan

Ordered part, the correct part came the next day. Read more

After sliding out the old shelf I removed the middle track from the old shelf & installed it with the new left side track on the new shelf. They basically click in & out. Slid the new shelf assembly in & put meat drawer in place. Read more

Ordered and installed new ones. Read more

Ordered and installed new ones. Read more

Right-side gasket replacement was straightforward. Left side required removal of mullion, which stumped me. I contacted Appliance Parts Pros who gave me the necessary instructions: Remove the center screw and lift up the mullion. Simple enough, once I knew how to do it. Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

Ordered a new one. Read more

I bought replacement parts Read more

I installed the new guides on shelf number two, which then became our shelf number one and one went into the empty two place. All is well now. Read more

Ordered the piece and put it in the refrigerator. Read more

My daughter forgot to close the drawer before closing the door and wammo!!! Easy fix, but hard on the wallet..AppliancePartsPros.com had it the cheapest. Read more

I ordered this part and replaced it myself. The photo confirmed I had the correct part. I removed the crisper drawers and all (took 1 minute) and couldn't figure out how to remove this part. Some of the notes claimed there were screws holding it on but that is not correct. One of the large tabs on this part is what keeps this part in place. It's the large tab just slightly to the rear of center. Press it and lift up and the part comes right out. You have to remove the crisper slider from the... Read more

My tenant actually put all of the parts on. Only took a few minutes with a screwdriver. Very easy to install. Read more

Although I only needed to replace the drawer support (end cap) on the right side the kit comes with replacements for both sides. I was surprised to see that the air flow adjustment mechanism that is located on the right side end cap was not included. I should mention that I did not disassemble the drawer mechanisms before ordering the end cap(s). The kit contained only the two molded end caps - no fasteners, mechanisms, or anything else. It turns out that this was all perfectly fine. The... Read more

Looked up the parts list and diagram by serial number. Found the correct part numbers and ordered 2 crisper drawers, the meat drawer and the bar that holds bottles on the bottom shelf of the door. The diagram showed endcaps needed on the bar, but that was only for if the bar was for the freezer door. Parts were a little expensive, but we're beautiful and delivered in just a few days. I have endcaps I don't need, but might need someday if any of them in the freezer we're to break. Overall, it... Read more

Replaced the door shelf with a new one Read more