Range Heating Element

Fridge keept building up ice in defrost drain drain in freezer. Once the drain pan filled with ice it drips into fridge compartment. After taking things apart three times to thaw it out, decided to replace defrost components - heater and temperature switch. In addition to new parts, also added a 12 gauge copper wire hook that hangs from defrost heater into the defrost drain. After this, the defrost cycle is running as expected, but will not know if the issue is corrected until a year or so... Read more

1st. replaced thermostat probe inside wall oven - no change. Then removed range heating element and measured it with ohm meter for continuity and found it to be OPEN. Ordered replacement range heating element; measured it before install and found it to be a few ohms - installed in less than 5 minutes and tested. ALL WORKS GREAT. Both items purchased with shipping were just over $100. (I chose to keep the thermostat probe instead of returning it being the oven is just over 10 years old). Read more

• Little to no heat when baking

I visited Appliance Pros website and indicated the problem we were having etc. Found the suspected part (heating element), went on YouTube and found out how to remove the part from the oven and test it with a multi-meter. Keep in mind I have never used a multi-meter before or made repairs to an oven before. However, I have used Appliance Pros before to fix a refrigerator problem just a month earlier and after watching their video it was a very easy repair. Anyway, I tested the old convection... Read more

• Element will not heat

Replace burner and receptacle. The product arrived promptly after order and the receptacle came in a factory Whirlpool bag, indicating it was a genuine Whirlpool part. The burner did not have such identification, but works very good. I've placed 3 orders with these folks for various broken appliances, and each one has worked as advertised and performs like new. Read more

• Element will not heat

This repair was on a GE glass Cooktop range. This range has two indicator lights, a Burner On light, and a Hot Cooktop Light. The problem I was having was, the Hot Cooktop stayed on all the time (24x7), even when the cooktop surface had been off for hours and was cold. YouTubes that I viewed were all misleading on this symptom. They all pointed to the switch, which is the fix for the Burner Light staying on, not the Hot Cooktop Light staying on. I figured it out by going to the schematic.... Read more

• Little to no heat when broiling
• Element will not heat

Replaced it. Read more

I replaced the bake element in the bottom of the unit. Read more

Replaced the oven heating element Read more

Pulled up you tube, watched video, ordered part, and installed. No problems Read more

• Element will not heat

Unplug range. Open oven door to gain access to the cook top lock-down screws, located under the front edge of the cook top. Tip the cook top up and carefully remove it by pulling forward. Set aside in a safe place. Remove old, burned-out, element by removing the single lock tab, located on one of the three mounting posts, then lift up. Leave the wiring attached. Flip the element over and remove the three mounting tabs, making note of their numbered locations. Transfer the mounting tabs to... Read more

Put in a new 6" surface burner. Read more

Installed the new pans and replaced the coils. My Jennaire looks like new. Only took minutes and made such a difference. Read more

Found the part number, went to AppliancePartsPros.com and found it within minutes. I ordered the part and it showed up at my house the following day, no special overnight shipping charges. I changed out the element in about 15 minutes. Great experience with AppliancePartsPros.com. Read more

Ordered replacement part, it shipped really fast. Part was exactly the right thing. Unscrewed 2 screws and pulled some slack out the wires. Disconnected the wire clips. Repeated steps to put in new part. Worked like a charm! Read more

I ordered a new one Read more

Ordered the dual element,only took 1 day for delivery,replaced element in about 15 min.and we're back in business Thanks Read more