Refrigerator Gasket & Seal

• Frost buildup

Arrived on time and was a good fit. no problems at all thank you Read more

• Door sweating

My co-worker bought a house to flip and gave me the refrigerator. I'd been looking for a garage refrigerator to store water, cola, etc in. Fridge was essentially fine but I sanded and painted one side which had rust spots. Turned out like new. The door seal was moldy and didn't seal properly. The only advice I can lend is to take the door off the hinges and lay it down flat. So much easier. With this seal you basically just take out all the screws, peel off old seal and set the new one... Read more

Bought this door gasket and watched the video, very easy if you just take your time and start in one corner and go to the opposite corner. this way it stretches the seal completely into each corner. do as the video says and it will go great. Read more

We replaced both the fresh food door and freezer door gaskets. Old gaskets must have lost their magnetic abilities. Read more

I look on the internet i came a cross appliance parts pros i didnt no what i was looking for so i call the phone number talk to someone gave him the info he ask for they has what i was looking for in stock the guy was very nice he say i will get the part in two days and i got it in two days if i need a part for anything else i will ckeck out appliance parts pros when the door gasket came my grandson put it on in a flash Read more

I took the new seal out of it's packaging and used a blowdryer on low heat to soften up the seal so that the crease from shipping (it was folded to ship) disappeared. Next I took the refrigerator door off, removed the old seal, & cleaned the area where the new seal would be applied. Following the video on the Appliance Pro Parts website, I re-installed the new seal and put the door back on. Last step was to snap on the new hinge cap I ordered. The video online was easy to follow and this... Read more

Removed front panel from refrigerator door and replaced the ice chute door seal and also replaced the seal inside the door that seals against the ice maker. Read more

Pulled gasket out of track and replaced with new one. Read more

Put in new one Read more

Took off the old ones, put on the new ones. Read more

• Door sweating

The video explains exactly how to remove the old refrigerator gasket and replace with the new one we ordered. Thank you for detailed explanations of how to do this project. Read more

Ordered replacement door seals, assistance picking the seals and speed of shipping was excellent. The installation was about as easy a job as can be, remove old seals, clean the doors and press in the new seals. With that said, I don't believe these are the same quality as factory original seals, the doors do not close as positive as the original and I have an air leak in the freezer door seal allowing condensation and ice to form. Read more

The new gasket arrived in a box half the size of the gasket so the gasket was folded to fit into the box. I hung the new gasket up for a couple of hours and then just prior to installation used a hair dryer as per included instructions to soften the gasket and minimize minor wrinkles in the gasket. The old gasket came out easily and the new went in easily. A 5 minute job in total. Read more

The gasket on my freezer door was not holding the door closes. When the main door closed, the pressure which shifts to the freezer was popping the door open and it was not closing because the magnet had lost its' mojo. I watched the video for the replacement of the gasket on the freezer door and my experience was exactly the same. One area that you should be mindful of: the depth of the fin on the replacement gasket is short, so do not make the slot of this fin too deep. When you are... Read more

• Door sweating

I went on the web and put in the refrigerator model. Several parts websites came up; I explored them all. All were approximately the same price, but I clicked on the installation video from AppliancePartsPros.com and was impressed with the thoroughness of the instructions. I knew it would be a huge help in putting on the gasket. So I ordered the gasket from them and it was delivered as promised. All in all, a very good transaction. Read more

Replaced Case Water Filter assembly DA81-05883A. Please read my post entirely before starting. I completed all the tasks that I could without having to disconnect the refrigerator since it was full of food. First I removed the panel on top of the refrigerator that covers the water line that feeds the dispenser. Do not disconnect any electrical connections or the water line at this time. Remove the panel from the back bottom of the refrigerator that covers the compressor and water valve,... Read more