Refrigerator Motor

I removed the fresh food ice maker found the drain tube for ice maker frozen. This was causing the back of the unit to rust out. This also caused the water to run down the back of the unit the into the duct work and into the freezer causing ice buildup. I then defrosted the freezer removed the rear duct work and the freezer drain pan cover. I found the freezer drain was not draining. I removed the exterior rear cardboard cover and located the freezer drain tube removed it and found that it was... Read more

• Noisy

After a lot of research on internet we thought it might be the condenser fan motor . we were a but confused as frig still working and cooling. I had imagined if motor gone bad it would just stop . However on taking back off frig we could see fan sometimes slowed and then began loud "animal " squeaking noise ! Although the back bottom of our fridge was relatively open it was very tricky to ease out fan and motor. Fortunately I had also ordered fan and grommet as fan was almost impossible to... Read more

Originally thought it was the evap fan motor, possibly the control board. Turns out it was the latter but only way to know for sure was to replace fan first. Shipping was fast and the parts were good. Read more

• Noisy

After noticing that the fan was not going on with the compressor, I used a small fan to cool the compressor until I got the new fan at which time I replaced the defective fan and the problem was solved. Read more

After tossing a couple for refrigerators to clean the storage area - we had one good one left taken from an apartment where the resident bought a newer-bigger one. Another resident's went bad - froze in the freezer - but 65 F in the lower refrigerator unit. Not my job but I decided to check it - diassembled the freezer plastic - fan didn't run - took it out and direct powered it - dead! I went on line and reviewed numerous Goolgle hits - yours was easiest to work in - put in the OEM P/N - you... Read more

Determined that the evaporator fan in the freezer compartment was not running properly and making noise. Ordered a replacement evaporator fan and blade. Removed the freezer door, baskets, and side rails. Removed the back panel of the freezer compartment by unscrewing and disconnecting the power cable connected to the fan. Removed fan blade. Turned over the panel and removed the back fan bracket and fan. Installed replacement fan, back fan bracket, and fan blade. The grommets ordered were the... Read more

Replaced the motor and fan blades exelente fitting work great Read more

I had found that the fan in the freezer was making a lot of noise. Turns out the shaft was loose, causing the flan blade to wobble. Replaced the motor and fan and now it runs like a new unit. Read more

REPLACED DEFROSTER, CONDENSER FAN MOTOR AND DEFROST THERMOSTAT. Read more

Replaced auger motor Read more

The evaporator fan had stopped working and caused the entire area around it to ice up. No air flow was getting from the freezer to the fridge. I replaced the damper control (it was rusted, not sure if it was workign or not) and the evaporator fan. It was a very quick repair once I diagnosed the problem. The most time consuming part was taking all the compartments apart to get to the affected area. Read more

• Noisy

I watched videos to diagnose the noise coming from my refrigerator, then watched videos on how to replace the part, then I ordered the replacement part which came very promptly. The part works perfectly. I am a 73-year old woman, and found this was an easy fix, even on a bottom freezer model refrigerator. The AppliancePartsPro price for this part is a good buy, and I will buy again when I need a part. I have ordered replacement parts from AppliancePartsPro for my cooking range previously and... Read more

Ordered parts, removed top tray in freezer, popped the back inside freezer panel out removed and replaced fan, dampers and fan housing. Took about 15 minutes. Read more

Added a new shaft as the old shaft had worn down...........works perfect now. Thank you Easy fix ....no more than 10 mins. Read more

The fan blade had vibrated down the shaft of motor and was hitting the fan supports. I replaced motor and new fan blade. The motor was still operating but since I had everything opened up I changed out the motor anyway. Freezer working fine now. The only unforeseen problem is there was a black wire that had to be transferred to the three prong wiring harness. Read more