Roper Parts

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

I bought replacement parts Read more

I just slid it in and snapped it into place. It was very easy! I am so grateful I was able to find this part at AppliancePartsPros.com. My refrigerator is fairly old and I wasn't sure the parts would still be available. Read more

Replaced the timer - This should have been a VERY easy repair however, there is a clip (holding the timer to panel) on the bottom of timer than must be removed with a pair of pliers. There is absolutely NO room to access this clip so I had to take apart much of the dryer to gain access. What should have been a 15 minute repair turned into a frustrating hour. Read more

Dishwasher washer would not drain after hearing glass-like particles during the drain cycle despite trying to clean the cylinder filter. Originally suspected the drain motor was damaged. After watching a video on how to replace the drain pump, I carefully energized the dishwasher (from water and electricity) then removed the dishwasher to take a look. After removal of drain hose from the pump, discovered that drain hose was connected to water inlet assembly which also needed removal to... Read more

Tried to put refrigerator in defrost mode and defrost would not initiate. Checked the bi-metal and heater, both tested good. Replaced the ADC board and refrigerator went in to defrost. problem solved. Read more

We ordered the parts from Appliance Parts Pros., and they fit perfect!!! (have replaced in the past with cheaper ones from local store/didn't fit right and didn't last) this would be the 4th or 5th time we've used Appliance Parts Pros and I keep coming back because they're AWESOME!! Online search is good; and if you have questions the instant chat/customer service is even better! Thank you Read more

• Freezer section too warm

New gaskets. from appliance parts pros Read more

Replaced Thermal Cutoff sensor. Read more

• Door sweating

Removed old door seal and replaced with the new one I purchased. Read more

• Ice maker dispenses too little ice
• Ice maker won't dispense ice

Plastic drum was broken and wasn't pushing the ice through the crusher teeth. Received my part pronto and made the repair. Was an easy fix, took about 15 min from start to finish. Everything working very good now. ( : Thanks for getting the parts to me so fast. I will definitely remember Appliance Pro if I need parts in the future. Read more

Ordered the parts from ApplianceParts Pros.com and saved the $100 service call. The fix was easy, complete instructions enclosed. Read more

I watched the videos for both jobs, which were excellent and "spot on" for the repair jobs.It didn't take me an hour to replace both lines. Keep up the good work on helping us repair and save money doing our own work. Ken Read more

• Little to no heat when broiling
• Little to no heat when baking
• Gas igniter glows, but will not light
• Won't start

Replaced the igniter, Simple but there are several points to remember. TURN THE POWER OFF 1) remove the oven door or you will have a hard time reaching the back of the oven. Mine just lifted off. 2) The igniter tip is fragile put a drop cloth over the oven floor in case you drop it even after it is in its holder. 3) The drop cloth will catch screws too if you drop them so they won't fall into the oven. 4) The cable from the oven is very short even after pulling it out from the hole at the back.... Read more

Looked up the parts list and diagram by serial number. Found the correct part numbers and ordered 2 crisper drawers, the meat drawer and the bar that holds bottles on the bottom shelf of the door. The diagram showed endcaps needed on the bar, but that was only for if the bar was for the freezer door. Parts were a little expensive, but we're beautiful and delivered in just a few days. I have endcaps I don't need, but might need someday if any of them in the freezer we're to break. Overall, it... Read more

Touch up paint Read more